1. When the working conditions of the exterior are changed (such as changing the medium, changing the ambient temperature, etc.), the zero position of the exterior should be adjusted from the beginning. At the same time, the outer surface of the catheter must be leveled and calibrated with a spirit level. Failure to do so will increase the effect of the change in operating conditions on the zero drift. Rack ...

1) The detected object should not touch the proximity switch, so as not to damage the proximity switch due to friction and bumping; 2) Pull the lead wire of the switch by hand will damage the switch close, and it is best to fix the lead wire with a line card at 10 cm away from the switch when the device is installed.

The temperature controller is an electrical switchgear that controls the temperature of an air-conditioned room. The temperature scale in the air-conditioned room controlled by the temperature controller is generally 18°C--28°C. The temperature controller commonly used in window air conditioners uses the principle of pressure effect to promote the opening and closing of contacts. Its structure consists of bellows ...

First, the standard scale of the busway Ottonix products in the shopping mall: 1. The products produced are all accessories products commonly used in industry, and they are widely applicable. 2. The product quality is stable, the production and the inspection are regular. Compared with domestic products, the stability of the product function ...

Reasons: 1. The polar surface of the communication core is uneven or the demagnetization air gap is too large; 2. The double coil of DC operation derived from the communication contactor is overheated due to the fact that the normally closed interlocking contact is not released by welding; 3. The frequency of operation is too high; 4. Poor coil manufacturing or due to mechanical damage, absolute ...

Autonics continuously improves the product function and quality, so that the product is at the international first-class level. For more than 10 years, the market share of the products in Korea has been maintained. 1. Adopt self-developed special IC ...

The Ottonix sensor BWC series has selected a 3-point light cross-network detection method to reduce the detection blind spot to the maximum limit, realize the world's leading detection characteristics, and effectively prevent problems that may be caused by direct sunlight, etc., and the detection is more stable. Up to 100 international cutting-edge ...

Proximity switches are the most commonly used solution for touchless detection. The most commonly used proximity sensor is inductive, that is, through electromagnetic waves, to sense metal objects near the detection surface of the sensor; In practice, this is a very simple tool for the detection of metal objects from one to two inches.

Leveraging the expertise accumulated in the development of industrial sensors, such as area sensors and mapping sensors, Ottonix has developed the SFL series (standard) and SFLA series (high-performance) safety light curtain systems that comply with the leading international standards/regulations. The product has built-in fingers/hands/people ...

On September 17, 2019, the 15th MM. New Automation Forum in 2019 with the theme of "Interconnection, Integration and Synergy" was successfully held in Shanghai.

Key 1: Whether the speed of the motor is normal, whether there is speed jitter and stalled rotation (you can check it with a tachometer). The key is whether the anchor bolts of the motor are loose, whether the root is defective, and whether there are debris around. The key is three, whether the housing and coupling of the motor are defective, ...

1. Measurement of action interval; When the action piece approaches the sensing surface of the switch from the front, the interval between the action of the switch is the interval between the action of the switch, and the measured data should be within the parameters of the product. 2. The Liberator ...

When the air conditioner cannot operate normally, in addition to checking the starting relay, overheating, overcurrent protector and capacitor of the compressor, it is also necessary to check the main control selection switch of the air conditioner thermostat, which is a very important control protection and actuator component in the electrical control system. Here are a few common types of air ...

Modular power supplies are power supplies that can be mounted directly on a printed circuit board and feature power supply to application-specific integrated circuits (ASICs), digital signal processors (DSPs), microprocessors, memories, field-programmable gate arrays (FPGAs), and other digital or analog loads.

Autonex has recently launched a new shading action form to add a space for users to choose. The BTF series of ultra-thin photoelectric sensors has a new dark ON form to increase the user's selection space. The selection of self-developed special IC, 3.7mm ultra-thin planning, suitable for small space ...

Dual PID auto-adjustment function There are high-speed response modes and slow reaction modes in the PID function. When you want to reach the desired value quickly, use the high-speed mode (PIDF mode) When you want to minimize overshoot, use slow mode (PIDS mode) ...

Autonics Solid State Relay SSR adds SR(H)2/3 three-phase solid state relay to its family of relays Autonex proudly introduces you to the new formation of solid state relays, three-phase solid state relays. Compact design, flexible devices, easy ...

Panel meter, also known as panel table or meter header, the full name is panel mounted instrument (panel mounted instrument), English Panel Meter. Because this kind of instrument is installed and fixed on the surface of the equipment for viewing and operation, it is called a panel table and is a functional part of the screen equipment. ...

The two are not universal Module power supplies are power supplies that can be mounted directly on a printed circuit board, and feature applications for application-specific integrated circuits (ASICs), digital signal processors (DSPs), microprocessors, memories, field-programmable gate arrays (FPGAs), and other digital or analog applications.

The TR1D series has a high-speed sampling period of 50ms and a display accuracy of ±0.3%, which can complete more accurate temperature control. Heating/cooling can be operated together to provide useful temperature control. With a width of only 22.5mm, the product minimizes the limitation of installation space and can be passed through ...

Sensors are the most fundamental and commonly used components in automation systems. Autonex offers a wide range of sensors including proximity switches, photoelectric sensors, fiber optic sensors, and pressure sensors, which are committed to maximizing the user's work efficiency. ​ ...