Delixi inverter installation and wiring

Create Date: 2024-8-30 12:03:23|Source: Delixi

1. The device of the inverter

1.1 The device environment requirements of the inverter

Ambient temperature - 10 °C - 40 °C;

Ambient humidity: The relative humidity does not exceed 90% (no condensation);

Other occasions that require no direct sunlight, no corrosive gas and flammable gas, and less dust, with an altitude of less than 1000m.

1.2 The device mode of the inverter

1.2.1 Wall-mounted devices

The inverter should be straight, and the interval between the inverter and the surrounding objects should meet the following conditions: the interval between the two sides should be ≥100mm; The upper and lower spacing ≥ 150mm.

1.2.2 Cabinet device

The inverter should be straightened.

A single inverter should be cooled outside the cabinet as much as possible (when the environment is relatively clean and the dust is less). When it is necessary to choose the cooling method in the cabinet for a single inverter, an exhaust cooling fan should be installed on the top of the cabinet, and as far as possible, it should be installed directly above the inverter, and a filter should be installed at the air inlet of the frame.

Multiple inverters should be installed side by side as much as possible, and if it is necessary to choose a longitudinal device, a partition should be installed between the two inverters.

                         Delixi inverter installation and wiring

2. The connection of the inverter

2.1 The connection of the main circuit of the inverter

2.1.1 The connection of the main circuit

The input lines (R, S, T) and output lines (U, V, W)** of the inverter cannot be misconnected or reversed.

More on that
Servo motor failure analysis - Delixi Servo motor failure analysis - Delixi

Three-phase communication servo motors are widely used, but after long-term operation, various problems will occur. Timely identification of the cause of the fault and corresponding treatment is an important task to prevent the spread of the fault and ensure the normal operation of the equipment. One...

Problems affecting the normal operation of the inverter - Delixi Problems affecting the normal operation of the inverter - Delixi

  Seriously affect the normal operation of the inverter. The core components of the inverter are IGBT power semiconductor switching components. When they are working properly, they generate a lot of heat. If there is no fan forced cooling, the sensing head will immediately detect (IGBT) overheating (IGBT) and send it ...

Delixi switching regulator basics Delixi switching regulator basics

1. What is a switching regulator? Switching voltage regulators, some people call it regulators, voltage regulator sources. Complete voltage regulation, is the demand control system (negative feedback), from the automatic control theory we know that when the voltage rises, it will be lowered through negative feedback, and when the voltage drops, it will be ...

Delixi time control switch adjustment method Delixi time control switch adjustment method

Press the undo function key first, then press and hold the school time function key, then adjust the time and date to the current moment, press the punctual function key again, adjust the time that needs to be closed and open to the specified value, if you need to set multiple groups, then press the punctual function key to set, without multiple groups ...

How to select Delixi voltage regulator How to select Delixi voltage regulator

1. For pure resistive loads such as incandescent lamps, resistance wires, electric furnaces and other equipment, the power of the voltage regulator should be 1.5 times the power of the load equipment - 2 times that of the load equipment, for example, if your electric furnace is about 250W, you can choose a voltage regulator with a power of 500W. 2. Rationality ...

Delixi molded case circuit breaker Icu=ICS understands Delixi molded case circuit breaker Icu=ICS understands

Delixi 3P air switch, rated current 630A, rated voltage 380V. The Icu=Ics=70kA of this circuit breaker. When the short-circuit current reaches 70kA, can the circuit breaker still be used? If it works, the ICU is already at its limit, which is a contradiction. If it can't be used, ICS is 70KA, which means ...

Regularly inspect the inverter steps and methods - Delixi Regularly inspect the inverter steps and methods - Delixi

When the VFD is viewed regularly, the power supply should be blocked, the operation of the VFD should be stopped, and the cover of the VFD should be removed. The first thing is to check the places that cannot be seen without downtime, or the places where it is difficult to find problems on a daily basis, as well as the inspection and adjustment of electrical characteristics. After blocking the VFD power supply, the main power ...

Type of use of AC regulated power supply Type of use of AC regulated power supply

(1) Ferromagnetic resonant communication regulator: a communication regulator composed of a full choke and a corresponding capacitor, with constant voltage voltammetry characteristics. The full type is a typical structure in the early stage of this type of regulator. It has simple structure, convenient production, wide allowable scale of input voltage, reliable operation, and overload energy.

The main functions of Delixi regulated power supply The main functions of Delixi regulated power supply

The primary effect of Delixi voltage regulator is, of course, to stabilize the voltage. When the grid voltage fluctuates instantaneously, the regulated power supply will compensate for the voltage amplitude with a response speed of 10-30ms 1. Stable voltage: Wangwen Shengyi, Delixi stabilizes ...

Delixi DZ47S wiring method Delixi DZ47S wiring method

The general leakage circuit breaker is used to wire the principle of the upper and lower lines, as long as the phase line and the zero line can be distinguished, between, the zero line is marked with N on the right, and the incoming and outgoing lines are the same. Delixi DZ47LE C40 ...

Delixi AC contactor fault causes and solutions Delixi AC contactor fault causes and solutions

First, the iron core may not be able to suction power Causes: The power supply voltage is too low or fluctuates too much, the power supply capacity of the operating circuit is lacking or the wire is broken and the control contact is poor, the technical parameters of the coil are inconsistent with the application conditions, and the product itself is damaged. Solution: Turn up the power ...

Analysis of various models of Delixi circuit breaker Analysis of various models of Delixi circuit breaker

CDB1 miniature circuit breaker is a current-limiting high-breaking miniature circuit breaker with overload and short-circuit two-layer maintenance, which is suitable for communicating 50Hz, additional voltage 400V and below, and additional current 63A and below circuits.

Methods for preventing breakdown of transformer insulation Methods for preventing breakdown of transformer insulation

1. Avoid water and air entering the transformer (1) The transformer should be protected from water ingress and moisture during operation, and it is necessary to seal well the cap of the casing item, the top of the storage phase, the bushing pipe and its connecting pipes. If necessary, a leak detection test should be carried out, and if the insulation has been found to be damp, it should be adopted in time.

Delixi surge protector knowledge quiz Delixi surge protector knowledge quiz

Many people don't know what a surge is, surge is also known as a surge or lightning protection maintainer, the first is to maintain the household electrical equipment when it rains and thunders to avoid being damaged by lightning, and when the lightning strikes high-voltage electricity is drained to the ground through the surge maintainer, it will not directly hit the electrical equipment ...

Delixi contactor has normally open point and normally closed point reasons Delixi contactor has normally open point and normally closed point reasons

If you're wondering why there are normally open and normally closed contacts in communication contactors, let's first look at what these contacts are used for. Normally open and normally closed contacts are electrical components used to complete self-locking, interlocking or interlocking tasks, and can also be used to control other components or signal indicators.

How to distinguish the authenticity of Delixi Electric How to distinguish the authenticity of Delixi Electric

Delixi switch socket real and false distinction 1. Appearance The shape of genuine Delixi switches is relatively fashionable, looks beautiful, neat appearance, and other impact resistance functions are relatively strong, not easy to crack or turn yellow. Whereas...

Delixi product parameter unit VF and V difference Delixi product parameter unit VF and V difference

Voltage vf and v difference: The two have different meanings, vf on the battery represents the feedback voltage, while v represents the capacity of the battery, which is the unit of measurement of voltage. Lithium battery is a kind of battery with lithium metal or lithium alloy as the positive/negative electrode data and the use of non-aqueous electrolyte solution. ...

Noise characteristics of different switching regulator topologies - Delixi Noise characteristics of different switching regulator topologies - Delixi

Currently, there are many different switching regulator topologies. Some topologies are widely used, such as the classic buck converter, also known as the buck converter. However, there are also some lesser-known switch-mode DC-DC converters that include Zeta topologies. These topologies are divided into fundamental topologies ...

Delixi inverter E180 series technical features Delixi inverter E180 series technical features

1. Superior performance The new vector control algorithm is adopted, and the starting cabinet is large, the torque response is fast, and the control accuracy is high, which further improves the operation efficiency of the motor. 2. Powerful function and low cost of use Built-in large number of ...

Delixi inverter common problems Delixi inverter common problems

1. The pressure of Delixi inverter system is unstable and simple vibration? Answer: The pressure of the system is unstable, which may be due to the following reasons: A. There is a problem with the orientation of the pressure of the pressure sensor collection system, the pressure collection point is too close to the water pump outlet, and the pipeline pressure is affected by the water outlet ...

CATEGORIES BYPASS
Customer Service Center

Online Consultation:QQ


ContactContact

Contact: Manager Huang

Contact QQ: 3271883383

Contact number: 13522565663


Scan the code to add WeChat (please save the picture first on the mobile phone)

working hoursworking hours

Weekdays: 9:00-17:00

Holidays: Only emergencies are handled

Contact us

Contact us

Contact number QQ consultation
QQ consultation

3271883383

Company address
Back to top