Rittal cabinets – what are the steps in the cabling of the cabinet?

1. The first is to measure how long the line is.

According to the decision is to put the location of the distribution frame, and then combine the distance of the wire from the outside into the cabinet, etc., calculate how long the network cable is needed to hit the distribution frame and install the cabinet, so as to facilitate the overall cable management behind, if the cable is placed in the cabinet is too long, it is easy to cause an unsightly situation, and the later cable management is more troublesome, and it is necessary to keep pulling back to neatly and beautifully sort out the cable.

Secondly, it is necessary to comprehensively consider how to walk after the cable enters the cabinet from the upper or lower part of the cabinet, try not to bend or bypass some things, and walk from the cabinet to the cabinet, and take into account that the direction of the wiring can not affect the entry of the network equipment later, which requires the staff to have a certain predictability.

2. Cut off the excess

Cropping is done according to the length measured in the first step. Cut off the excess, pay attention to try to be consistent to avoid affecting the appearance, and leave a part of the redundancy than the calculation, preferably ten to fifteen centimeters, including cutting off the foreskin and the length of the patch panel. At this point, there is no need to put the cable into the cabinet from the outside, as it will be difficult to manage the cable.

3. Next, start the cable management

Start tying the cable tie with a cable tie where the root of the cable starts to be exposed.

The use of the distribution board is to pass the cable from the back of the distribution board through the distribution board one by one according to an agreement, and tie up the back of the distribution board with two continuous network cables together in the back of the distribution board, and every two pieces of tie together are required to have a dislocation, that is, do not tie too much side by side, every two cable ties up and down is best a little distance, after two continuous ties are tied up, six network cables will be tied together on average, and they need to be re-tied every half a meter on average. Pay attention to neatness when tying, and don't tie it together to give people a feeling of disharmony.

4. Tie the wire

Use the cable management board to move down all the way, and wrap the back of the cable management board with a cable tie (half a meter each). The last six roots are tied at the end of the offline cable about one meter, and after they are tied, they start two at a distance nearby, of course, they are tied in order. After every two roots are tied, use the same method to tie them again about half a meter down, which is conducive to the next step of playing the wiring frame.

5. Hit the distribution frame

The following is to start the distribution frame, because the above work has been done after the cable has been very clear, throw the cable to the outside of the cabinet and start to place it on a workbench in a group of three to start the work of crimping the line. If you crimp the line in a pre-arranged position, you will not be able to make mistakes. The specific process steps of the crimping line will not be repeated here.

6. Test the beaten distribution frame,

After the test is completed, the cabinet will be installed, and the network cable will be tied according to the original plan after installation, so as to achieve neat and beautiful horizontal and vertical alignment. The connectivity of each point is recorded, and if it is consistently unpassable, it needs to be recorded in the note log.

Rittal cabinets – what are the steps in the cabling of the cabinet?

This article comes from the Internet, if there is any infringement, please contact this site to delete.

Rittal cabinets – what are the steps in the cabling of the cabinet?

Sections viewed

Contact

working hours