NACHI Fujikoshi--ZT Extrusion Taps Extrusion tap series No chips are generated, and stable machining is possible Extrusion taps for enhanced thread strength ZT coating It has excellent wear resistance, heat resistance, and low friction properties Sump ZT Blade (PAT. P) ...

1. Control errors - these are the faults in the control system, software, electromagnetic interference and radio frequency interference. If the control system is faulty, this can cause the machine to behave abnormally or increase the potential risk energy. 2. Unauthorized visits – those who are not familiar with security hardware ...

Failure of the teach pendant is a common problem. If the touch pendant is poor or partially ineffective during the maintenance process, the touch panel needs to be replaced in time. If there is no display, then it is necessary to repair or completely replace the internal motherboard or LCD screen ...

Clean the outside of the robot Use a gentle detergent to clean the spot. Do not use strong solvents. Note: Don't engulf the Spot. Spot is able to resist subtle water mist, but does not use a sprinkler to force spray or submerge in water. Submerging Spot will damage the robot ...

Nazhi robot application command function

Nazhi PZH series piston pump realizes continuous drive with an output pressure of 35MPa PZH-3B (2018-) Sold as our first high-pressure variable displacement piston pump for motors up to 90kW, it has low friction loss and internal leakage of each sliding part. ...

A customer who makes glassware, when the robot is powered on and running, it is still normal when it first moves slightly, but when it moves with large fluctuations, it begins to oscillate violently, and the oscillation fluctuates greatly, and he feels like he is going to fall to the ground, so he quickly stops the machine and turns off the power in a panic. Dimension...

In the robot welding cell, the disc acts as a buffer between the device base and the robot arm. Its planning is sacrificial. If the torch, bracket or gripper is bumped, the disc absorbs most of the impact. However, when the disc is struck hard by the neck or torch holder ...

User encryption settings When you want the program not to be modified by mistake, you need to encrypt the program on the teach pendant, and the operation method is: click once on the teach pendant: constant setting -- > control environment -- > password (password) change After confirmation, enter the following interface, and in the password ...

The eyes are looking at the robot, not the screen. Pay attention to the direction of the robot while operating. There will be situations where the cable will be entangled in the direction of the wrist rotation, and the tool will touch the robot, so be sure to handle it carefully. In order to prevent these situations, the operator's visual vision is the only ...

Put into operation ready for servo operation 1. Determine whether it is in teach-in mode, if not, it will be switched to teach-in mode. Straighten the buttons on the hand-knitted to teach; Turn the key button on the controller to teach-in mode; 2. Select the power-on button 3. Hold the micro-movement behind the hand knitter ...

Introduction to the working principle of the Nachi Fujikoshi palletizing robot 　　Inspection and grabbing: the sorted packaging bag arrives at the grabbing roller table, and after the manipulator inspects that there is a packaging bag (packing box) on the grabbing roller table, the manipulator arrives at the positioning point and turns to the packaging bag (packing box), and the manipulator opens and clamps the packaging bag into the ...