Compared with traditional computers, the characteristics of industrial computers - EVOC

With the growing demand for new technologies, in the development of touch products, capacitive touch screens are becoming larger and larger, and the use of writing devices similar to paper and pen has become more intuitive and convenient. The most common way manufacturers can support the function of a stylus is to use an active stylus ...

Memory is one of the most important components in industrial motherboards, which is mainly used to temporarily store the computing data in the CPU and the data exchanged by external memory. In the operation of industrial computers, there may be incompatibility between memory and industrial motherboards. The following is an introduction to the incompatibility of memory with industrial motherboards ...

When selecting industrial computers, we often encounter PCI and PCI-e expansion slots, what are the differences between the two? 1. Different colors. In IPC motherboards, the PCI slot is milky white, while the PCI-e slot is black. 2. The transmission rate is different. PCI slot max data ...

There are many internal structures of industrial computers, and most of the hardware is installed inside the industrial computers, such as passive backplanes, industrial power supplies, CPUs, motherboards, memory, hard disks, graphics cards, fans, etc. 1. Passive base plate. The slots of the passive backplane consist of multiple slots for the ISA and PCI buses ...

After the IPC is infected by viruses or hackers, the engine area of the hard disk may be damaged, or the hard disk or partition may be lost. This problem is usually caused by hackers or viruses correcting the boot area of the hard drive or encrypting the partition table or moving the sectors of the boot area. ...

M90 is an AI intelligent edge manipulator that supports 8-16Tops independent deduction and computing capabilities. Intel Q370 chipset, support 9th generation Core series low-power processors, 2 260-pin DDR4 SODIMM expansion slots, dual-channel DDR4 2400 MHz (up to 32 GB...

Memory is one of the most important components in an industrial motherboard, which is mainly used to temporarily store the computing data in the CPU and the data communicated by the external memory. In the operation of industrial computers, there may be incompatibility between memory and industrial motherboards. Memory is mainly composed of memory chips, circuit boards and gold fingers, etc.

If you are sure to use Advantech's industrial computer, then you must understand whether you need Advantech's original machine or a dealer's assembly machine. Taiwan industrial computer in the early stage of entering the domestic market did not have the original machine, that is, the chassis and motherboard, the rest are assembled by dealers. Later, there was the original ...

The ambient humidity is not suitable. The industrial computer is mainly composed of integrated circuits of many electronic components, and its insulation function is greatly related to the ambient humidity. If the humidity is too high, it is easy to form a short circuit and burn the circuit board; If the humidity is too small, it is easy to generate static electricity, and it will also break down some electronic components.

The control motherboard has CPU slots, memory slots, and some components, and the USB interface used in general use, etc., any problem on the industrial control motherboard will cause the entire industrial control motherboard to be paralyzed, and the industrial computer is also instantly paralyzed, so how to quickly deal with the daily problems and repairs of the industrial computer motherboard? ...

Serial port is a very common device communication protocol on industrial motherboards, and most industrial motherboards contain more than two serial ports based on RS-232. The serial port sends and receives bytes on a bit-by-bit basis, which is slower than parallel communication on a byte-by-byte basis, but the serial port can be used in the use of a single wire.

1. There is a display when the machine is turned on, but the screen is very dark, and there is no change after debugging with the brightness function button; 2. The white screen of the touch screen (no text and pictures) may be blurry, but the display is normal; 3. There are horizontal or longitudinal bright lines and bright bands on the touch screen; ...

　　First, the system overview The automatic telecontrol information commissioning of the substation is a necessary operation to be completed before the new substation is put into operation, and it is necessary to debug it after the opening of the supporting optical fiber channel of the substation in the past. In recent years, there has been a lot of growth by ...

1. 4U industrial computer 4U IPC refers to a 19-inch rack-mounted IPC with a height of 4U and ATX architecture. U is a unit that represents the external scale of the server, which is an abbreviation for unit, and the specific scale is determined by the United States Electronics Industries Association (EIA). The reason why it is necessary to regulate ...

The traditional industrial computer uses a combination of 4U and other types of cold-rolled plate chassis + gold finger motherboard (full-length or half-length card) + base plate + high-power power supply. There are a number of unstable elements to such a structure: 1. If the CPU card is inserted into the baseboard, there will be a bad touch phenomenon, such as vibration.

With the increasing use of the network, preventing hackers from intrusion and malicious damage by competitors has become a key issue in the use of network security.

(1) Chassis The chassis contains a power supply, a passive backplane, a fan, and more. The power supply is for long-term uninterrupted start-up service, requiring good performance, with over-voltage, over-current maintenance, anti-static, lightning protection and other characteristics. In daily life, it is necessary to pay attention to the dust entering the power fan, so as to prevent the operation of the power supply from being affected.

In fact, there is not much difference between the industrial computer and the ordinary computer, but the power supply and motherboard are nominally more stable and reliable than the ordinary computer, after all, the requirements of the industrial site are a little higher than the civilian one, and the so-called industrial computer encounters similar problems to ordinary computers, such as the black screen of the crash can not be started ...

First, the system overview VoIP gateways use existing IP data networks or the Internet to provide guessable, real-time, long-distance quality voice and fax communications. In this use case, the VoIP gateway provides a reasonable business communication for small and medium-sized business planning.

PC (personal computer) is derived from IBM's first desktop computer type, PC, in 1978, which is a personal computer that can run independently and perform specific functions. Personal computers do not need to share resources such as processing, disks, and printers from other computers ...