Features:
Operation mode ON when shading and ON when light is in (switchable type)
High-speed response with a response frequency of 1kHz
The light entry indicator is clear for easy operation confirmation
The power supply voltage is DC5 - 24V wide range
It is equipped with a light type that turns on the light when shading
There are 8 types of shapes and types
Flex-resistant wires with excellent flexibility are used as standard*2
Product parameters
class | Standard | L-shaped | T-shaped
The center of the groove is 7mm | T-shaped
The center of the groove is 10mm | NPN | Connector type | EE-SX670
EE-SX670A
EE-SX470 | EE-SX671
EE-SX671A
EE-SX471 | EE-SX672
EE-SX672A
EE-SX472 | EE-SX675 | Lead-out type | EE-SX670-WR | EE-SX671-WR | EE-SX672-WR | EE-SX675-WR | PNP | Connector type | EE-SX670P
EE-SX670R | EE-SX671P
EE-SX671R | EE-SX672P
EE-SX672R | EE-SX675P | Lead-out type | EE-SX670P-WR | EE-SX671P-WR | EE-SX672P-WR | EE-SX675P-WR | Detection distance | 5mm (Groove width) | Standard detection of objects | 2× Opaque objects of 0.8mm or more | Tolerance distance | 0.025mm or less | Light source (maximum luminous wavelength) | GaAs IR light-emitting diode (940nm) | Indicator*1 | Illumination (red) when light is in (Type A and Type R is illuminated when shading) | Supply voltage | DC5~24V±10% ripple (p-p) 10% or less | Current consumption | 12 mA or less (connector type, when L terminal is open), 35 mA or less (NPN lead type), 30 mA or less (PNP lead out type) | Control the output | NPN type: NPN open connector output DC5~24V 100mA or less
Residual voltage 0.8 V or less (at load current 100 mA), residual voltage 0.4 V or less (at load current 40 mA), shutdown current (leakage current) 0.5 mA or less
PNP type: PNP open connector output DC5~24V 50mA or less
The residual voltage is 1.3 V or less (at a load current of 50 mA) and the shutdown current (leakage current) is 0.5 mA or less | Response frequency*2 | 1 kHz or more (average 3 kHz) | Use ambient illumination | Luminance of the light-receiving surface Fluorescent lamp: 1,000lx or less | Ambient temperature range | Operating: -25~+55°C Storage: -30~+80°C (no icing, condensation) | Ambient humidity range | Operating: 5~85%RH Storage: 5~95%RH (no icing, condensation) | Vibration (Durable) | 20~2,000Hz (maximum acceleration 100m/s2) Up and down amplitude: 1.5mm X, Y, Z 2h (4min cycle) | Impact (Durable) | 500m/s2 3 times in each direction of X, Y and Z | Protective structure | IP50 IEC60529 specification | Connection | Connector type (direct soldering), Wire lead type (standard wire length 1 m), Connector relay type (standard wire length 0.1 m) | quality
(After Packing) | Connector type | Approximately 3.1 g | About 3g | Approximately 2.4g | Approximately 2.7 g | Lead-out type | Approximately 18.9 g | Approximately 17.3 g | Approximately 17.8 g | Approximately 18.3 g | Material | enclosure | Polybutylene terephthalate (PBT) | Cover projection, light receiving part | polycarbonate |
If you are interested in our ORMON Omron proximity switch EE-SX671 with a response frequency of 1kHz, please call our staff, looking forward to your call~
|
More on that
|
Omron S8VK-X Switching Power Supply Service life*: more than 10 years
Introduction: Omron S8VK-X switching power supply Service life *: More than 10 years, static input fluctuation *: 0.5% or less, IoT conversion of EtherNet/IP, Modbus TCP compatible devices.
peculiarity
With communication function, the size is small*1
Excellent environmental resistance ...
|
|
Omron NL Limit Contact Switch Degree of protection: IP60
Introduction: Omron NL limit contact switch IP60 degree of protection, leakage performance: (PTI) 175, built-in LED indicator to ensure easy operation and monitoring, DC type and S3D2 sensor controller combination to provide a variety of functions.
peculiarity
Instantaneous operation on contact, hysteresis pole ...
|
|
Omron S8VK-E Switching Power Supply (120W Type) Mass: 620g
Introduction:Omron S8VK-E Switching Power Supply (120W Type) Weight: 620g, Rated Power: 120W, Suitable for Charging Pile Industry Switching Power Supply CCC Safety Certification, Environmental Resistance, Three-proof Coating Correspondence, Minus 40 Degrees Can Be Started,
peculiarity
Operating temperature range -25 ...
|
|
Omron TP70 Tentacle Switch Protection Rating *1: IP65
Introduction: Omron TP70 Tentacle Switch Protection Rating *1: IP65, Allowable Operating Speed: 1 mm/s ~ 0.5 m/s, models with emergency stop switch are available to suit the application.
peculiarity
The combination of plastic tentacle drive levers makes it easy to handle the switch.
...
|
|
Omron D5B Mechanical Contact Switch Degree of protection: IP67
Introduction: The Omron D5B mechanical contact switch is ideal for inspecting objects from multiple directions, with high precision, and robots. Protection level: IP67, allowable operating speed: 5~500mm/s.
peculiarity
Adopt a slow-acting switching mechanism.
Gold-plated contacts, capable of opening ...
|
|
Omron D41G High Code Guard Lock Safety Door Switch Latching force: 30N
Introduction: Omron D41G High Coding Guard Lock Safety Door Switch Latching Force: 30N, Rated Insulation Voltage (Ui) DC32V, Rated Short-Circuit Current: 100A, D41 Series helps you create safety precautions that meet ISO14119 standards.
peculiarity
No tampering ...
|
|
Omron dip switch A7D/A7DP has a continuous current carrying capacity of 100 mA
Introduction: Omron DIP Switch A7D/A7DP is an ultra-small, low-cost, push-to-operate switch with contact resistance: 200mΩ max, shock resistance of more than 500m/s2.
peculiarity
The all-in-one design means fewer parts are needed. This product is characterized by a low ...
|
|
Omron Safety Limit Switch D4B-□N Ambient humidity: 95% or less
peculiarity
A new force-open action device (NC contact only) has been added to disconnect the contact in the event of a fault such as a contact blowing.
The safety of the pendulum setting ensures that a gear meshing device is adopted between the action position indicator panel and the pendulum.
Equipped with the ability to ...
|
|
Omron A165E E/E Emergency Stop Switch PTI (Tracking Characteristics): 175
Introduction: Omron/Omron A165E Emergency Stop Switch PTI (Tracking Characteristics): 175, Ambient humidity: 35%~85%, in accordance with EN 60947-5-5 standard, equipped with a safety lock to prevent abuse.
peculiarity
The forced disconnect structure can be used to force the ...
|
|
Omron DC Power Supply Electrode Level Switch 61F-GPN-BT / -BC
Omron DC Power Electrode Level Switch 61F-GPN-BT / -BC In the absence of AC power, it can be driven by a battery (DC24V). In addition, the voltage between the electrodes is an alternating sine wave, and there is no electric erosion, so it can achieve stable detection
Self-sustaining via loop processing, with the option of ...
|
|
Omron Buoyless Switch 61F-GP-N Compact, plug-in version
The Omron Buoyless Switch 61F-GP-N is suitable for the miniaturization of control cabinets, the space-saving design and easy maintenance
It is a compact size of 49.4 mm in height× 38 mm in width × 84 mm in depth.
With LED action display function, the action status is clear at a glance.
The output of the 11-pin type ensures independent 2 ...
|
|
Omron D4NA safety limit open heteroterminal room: 4kV
Introduction: Omron D4NA is an economical safety limit switch, off insulation resistance: more than 100MΩ, contact spacing: 2 × 0.5mm or more, standardized gold-plated contacts to ensure high reliability of contact.
peculiarity
Standardized gold-plated contacts guarantee a high contact ...
|
|
OMRON Limit Switch WLCA12-2NLD-N 50/60Hz
Product parameters
If you are interested in our OMRON Limit Switch WLCA12-2NLD-N 50/60Hz, please call our staff, looking forward to your call~
|
|
OMRON safety switch D4NL-4AFG-B 50/60Hz, 2.5kV
Features:
Selectable access to the operating key, insertion direction and adjustable mounting ensure installation flexibility.
Built-in switch with multi-contact structure.
The locking force is 1300N or more.
Can be used for general or micro loads.
The new M20 ...
|
|
OMRON Safety Door Switch Operation Key D4DS-K2 2NC/1NO
Product Introduction
A new generation of multi-contact safety door switch saves labor and is beneficial to environmental protection.
Features:
In addition to the original 1NC/1NO and 2NC contact structures, the product series has added 3-contact type and MBB M12 connectors equipped with 2NC/1NO and 3NC contact structures.
|
|
Omron A7PS/A7PH DIP Switches The maximum contact resistance is 300mΩ
Introduction: Omron/Omron A7PS/A7PH dip switch is a dust-proof, easy-to-use, setting switch with large display characters, vibration resistance: 10~55Hz, 1.5mm double amplitude, more than 2 hours.
peculiarity
The simple press mechanism and the large easy-to-view digital display make for ...
|
|
Omron Switching Power Supply S8VK-X has no cooling fan
peculiarity
With communication function, size**small*1
Excellent environmental resistance contributes to the stable operation of the plant
Support a wide range of communication methods in various fields
The status is displayed on the body monitor, which is more convenient to use in various scenarios
The fuselage monitor adopts a clear ...
|
|
Omron S8VK-WA switching power supply Power factor: 0.9 or more
Introduction: Three-phase 200V series input specifications are available. Solving the issue of balancing the semiconductor and FPD industries. Three LEDs are used to quickly identify anomalous areas. 150% peak current enables high-power load start-up
peculiarity
There is no need for cumbersome design for single-phase power supply, with ...
|
|
Omron A7CN / A7CN-L DIP Switch Continuous current carrying: 1A
Introduction: Omron/Omron A7C series miniature DIP switch is a new lineup of the brand, contact resistance: maximum 200mΩ, maximum operating force: 4.41 N or less.
peculiarity
This series includes all locking types to prevent accidental operation.
parameter
This article introduces the Omron/...
|
|
Omron Special Standard Switch DZ Mass approx. 30~50g
Introduction: DPDT standard switch for control of two independent circuits
peculiarity
It is well suited for switching circuit operation at different voltages and for controlling two independent circuits.
It is interchangeable with the Omron Z standard type switch because of the mounting hole size of the two switches, the mounting ...
|
|
Contact
working hours
