CHINT/CHINT LW6 series universal transfer switch

NH3-100 disconnector (hereinafter referred to as the switch) is suitable for AC 50Hz, rated voltage to 230V or 400V, rated current to 100A in the resistance and inductance mixed circuit, mainly for no load to turn on or off the circuit, for the line and power supply to turn on or isolate. Especially suitable for line ...

Molded case circuit breaker, in the distribution line and equipment overload, short circuit, to provide protection for the line and equipment, but also to the infrequent start of the motor to provide overload, short circuit protection. ● Shell Frame Grade NXMS Series Electronic Circuit Breaker: 160A, 250A, 400A, 630A, 100...

NX30 series open/concealed distribution box (box) (hereinafter referred to as the box) is a device suitable for installing 9mm modulus terminal electrical components, it has the characteristics of using electrical size modularization, installation rail, artistic appearance, safety of use, etc., it is suitable for AC 50 ...

During the working process, the leakage protection function is regularly diagnosed by itself (detected every 108 minutes), and the user will be reminded through the alarm module when the leakage protection function of the product is abnormal Rated current (In): 6A, 10A, 16A, 20A, 25A, 32A, 40A, 50A, 63A; Rated ...

Rated operating current at different rated operating voltages: Action characteristics: The wiring principle of the auxiliary contact is shown in Figure 1. When the auxiliary contact is opened, the 11th and 12th terminals are turned on; When the auxiliary contact is closed, the 11th and 14th terminals are turned on. Life: The operating life of the auxiliary contact is 10,000 times. This article describes ...

NU6-II. series surge protector is suitable for AC 50Hz, rated voltage of single-phase 230V/three-phase 400V power distribution and control system, to meet the SPDII. level test, used to suppress the transient overvoltage below the equipment withstand impulse overvoltage, discharge surge energy, so as to protect the system circuit and equipment. Suitable...

CJ19 series switching capacitor contactor (hereinafter referred to as contactor) is mainly used in power lines with AC 50Hz (or 60Hz) and rated working voltage to 690V, which is used for low-voltage reactive power compensation equipment to put in or remove low-voltage shunt capacitors. Contactors with inhibition ...

PZ30 series open/concealed distribution box (box) (hereinafter referred to as the box) is a device suitable for installing 9mm modularized terminal electrical components, it has the characteristics of using electrical size modularization, installation rail, artistic appearance, safety of use, etc., it is suitable for AC 50 ...

The Ex9PL series indicator and buzzer board has a front height of 8mm, a curved surface design, and indicators of various voltage levels to meet various applications. The light-emitting module adopts LED, which has high brightness, low energy consumption and long life. The lamp head protection grade is IP65, which is suitable for harsh environments. The buzzer has a continuous ...

The NXHB-125 disconnector complies with IEC60898 and GB10963 standards. It is suitable for AC 50Hz or 60Hz, rated voltage 250V and below residential single-phase lines, to protect the overload and short circuit of electrical lines. The product has high breaking capacity, small size and a width of only 18mm. Zero, fire ...

Introduction: CJX1-K series AC vacuum contactor (hereinafter referred to as contactor), mainly used for AC 50Hz-60Hz, rated insulation voltage of 1000V, rated working voltage of 380V under the AC-3 use category of rated working current to 820A in the circuit, for long-distance connection and disconnection ...

NCH8G series household AC contactor (hereinafter referred to as contactor) is mainly suitable for AC 50Hz (or 60Hz), rated working voltage to 400V rated working current to 63A circuit, control household appliances and similar uses of low-inductance and micro-inductance loads; It can also be used to control household ...

DZ267-32 miniature circuit breaker (hereinafter referred to as circuit breaker) is mainly suitable for AC 50Hz, rated voltage 230V, rated current to 32A in the line for overload and short circuit protection, but also can be used as an infrequent conversion of the line under normal circumstances, especially suitable for residential lighting ...

The new NXC series AC contactor has a novel appearance and compact structure. It is mainly used to start and control AC motors frequently, turn on and break circuits at long distances, and can form electromagnetic starters with appropriate thermal overload relays. Standards: GB/T 14048.1/IEC 60947-1, ...

CJ40 series AC contactor (hereinafter referred to as contactor) is mainly used for switching and breaking circuits in power systems with AC 50Hz or 60Hz, rated voltage to 660V or 1140V, and current to 1000A.

CJ20 series AC contactor (hereinafter referred to as contactor) is mainly used in AC 50Hz (or 60Hz), rated working voltage to 660V, rated working current to 630A, for long-distance switching and breaking circuits, and can be combined with appropriate thermal overload relays.

NXAF series universal circuit breaker is suitable for AC 50/60Hz, rated working voltage to AC690V, rated working current to 4000A and below in the distribution network, used to distribute electric energy and protect lines and power equipment from overload, undervoltage, short circuit, single-phase grounding and other faults; The break ...

CHINT/CHINT NXBLE-63Y residual current action circuit breaker Rated current (In): 6A, 10A, 16A, 20A, 25A, 32A, 40A, 50A, 63A; Rated residual operating current (IOn): 0.01A, 0.03A, 0.05A, 0.075A, 0.1A, 0.3A; Rated operating voltage (Ue): 2 ...

The universal transfer switch is mainly suitable for AC 50Hz, rated working voltage 440V and below, DC voltage 240V and below electrical circuits, for manual infrequent connection or breaking of circuits. It is mainly used for the conversion of various control lines, commutation measurement control of voltmeter and ammeter, and distribution.

AX-7 auxiliary contact is mainly used in the line of AC 50Hz, the agreed heating current to 3A, the AC rated voltage to 415V or the DC rated voltage to 125V, and is assembled with the NB7 miniature circuit breaker for the signal indication of the long-distance circuit breaker on/off. Standards: GB/T 14048.5, IEC...