Honeywell/Honeywell flow sensors AWM92100V non-amplified

Honeywell Sensors JSM802UD1Y Cylindrical Sensors JSM8 Series Rated: 12VDC-24VDC Load current: ≤100mA Inductive Proximity Sensors: Rectangles: JPA17 series, JPA25 series, JPA30 series, JPA40 series Cylindrical: J ...

Introduction: Honeywell's TBP series of compensated and non-amplified basic board-mount pressure sensors are specifically designed piezoresistive silicon pressure sensors. This series of sensors is simple and easy to operate, excellent quality, cost-effective, mV output, non-amplification and temperature compensation.

Introduction: The AWM5000 Series Microbridge Mass Flow Sensors feature a venturi flow housing. This series measures airflow of up to 20 standard liters per minute (SLPM) while generating a maximum pressure drop of 2.25" H2O. The microbridge chip is in direct contact with the airflow, which greatly ...

Introduction: The AWM700 series microbridge mass flow sensors enable coaxial flow measurement with a specially designed bypass flow housing. The sensor can measure flow rates up to 200 standard liters per minute (SLPM) while typically generating a pressure drop of 1 in H2O. The AWM700 features ...

City Technology's Series 7 sensors are suitable for gas detection, including oxygen and toxic gases. The sensors are suitable for portable detectors, fixed detectors, and some medical gas detection. City Tech's Series 7 is suitable for including oxygen and ...

HONYWELL DPT2500U1-A Sensors DPT Series Air Differential Pressure Sensors Measuring range: 0 - 2500 Output signal: 4-20mA All-stainless steel capacitive sensitive components • Good temperature stability and long-term stability • Power miswiring protection • Flip cover ...

The Series 3 is City Technology's oldest family of gas sensors. A wide range of sensors have evolved from this series and are available with 4mA to 20mA and mV transmission boards. The Series 7 is an upgrade to the series. This article introduces the Honeywell/Honeywell ...

General Purpose Gauge/Absolute-Pressure Transducer from 0.5 psig to 60,000 psig (Absolute) with ±0.25% Full-Scale Accuracy The Model Z pressure sensor is made of 17-4 PH stainless steel, wetted material that can withstand pressures up to 2,000 psi, and 15-5 PH stainless steel, which can withstand ...

Compensatory. As low as ±0.25 %FSS TEB. Ultra-low (differential, gauge), low (absolute, differential, gauge). 24-bit digital SPI-compatible output. DIP，SMT Pressure range ± 1.6 mbar to ±10 bar, ± 160 Pa to ±1 MPa, ± 0.5 inH2 ...

E-I tested matching beads on the fitting assembly. -60°C to 300°C [-76°F to 572°F] The 115 series thermistors consist of two beads, each mounted on a special hermetically sealed joint. High resistance thermistors should be used at high ambient temperatures to achieve the most ...

The CRIR series is a single-channel, non-dispersive infrared (NDIR) sensor. The CRIR M1 and CRIR E1 have a sensing cavity with an infrared light source at one end and a detector with a filter on the other. The light source emits a wavelength of radiation that includes a CO2 absorption band. Filters block ...

HONYWELL DPT5000U1-A Sensor DPT Series Air Differential Pressure Sensor Measuring range: 0-5000 Output signal: 4-20mA Sensor: DPT series air pressure differential sensor All-stainless steel capacitive sensing element • Good temperature stability and long-term stability ...

The i-Series intelligent gas sensors are compact, low-profile sensors based on City Technology's proven solutions. The service life of these sensors has been extended to 5 years, and the operating temperature and humidity range has been significantly expanded. Compact, pre-calibrated, predictive ...

Summary: The HSC series is capable of performing comprehensive calibration and temperature compensation for sensor zero, sensitivity, temperature coefficient, and nonlinearity using an application-specific integrated circuit (ASIC) on the board. Calibrated analog output values and digital outputs are updated at a rate of approx. 1 kHz and 2 kHz, respectively ...

Honeywell's DT series of micro differential pressure transmitters are used to measure differential pressure or gauge pressure, and provide a variety of measuring ranges as low as +/-50Pa and as high as 0-l0kPa, suitable for: VC HVAC, intelligent building energy management, VAV and damper control. Product Features: · All stainless steel capacitive sensitive components ...

Summary: The SSC series is capable of performing comprehensive calibration and temperature compensation for sensor zero, sensitivity, temperature coefficient, and nonlinearity using an application-specific integrated circuit (ASIC) on the circuit board. Calibrated analog output values and digital outputs are updated at a rate of approx. 1 kHz and 2 kHz, respectively ...

Digital pressure indicator. High pressure type, 15 psi to 60,000 psi. Accuracy: 0.1% FS This model includes a pressure sensor and digital readout combination and is designed for industrial and laboratory applications. Accu-Gage offers portability, high accuracy, industrial-grade durability, and a highly competitive ...

Description: The RSC series is a piezoresistive silicon pressure sensor capable of taking pressure readings from either a digital output or an analog output within a specified full-scale pressure span and temperature range. Through a 24-bit analog-to-digital converter equipped with integrated EEPROM, it is possible to control sensor offset, sensitivity, temperature, etc.

Hall-effect or anisotropic magnetoresistive (AMR) sensor ICs for digital or linear output of angle, position, and velocity sensing; Value-added suites. You know we're ahead of the curve. In 1968, we combined Hall-effect sensing and related electronics in a single circuit ...

Introduction: The AWM90000 series of mass flow sensors feature time-proven thermal bridge technology. The AWM90000 Series offers many of the benefits of the AWM1000 Series in a more cost-effective platform. Available in both mass flow and differential pressure versions.