The PLC-INTERFACE is suitable for high inrush currents and consists of PLC-BPT.../1 IC/ACT base terminal with plug-in connection with plug-in miniature relay for mounting on DIN rail NS 35/7.5 with an inrush current of up to 130 A, 1 NO contact, input voltage 24 V DC
advantage
The type of actuator used guarantees a direct connection to the load loop
Efficient system connectivity via V8 adapter
Secure isolation between coil and contact in accordance with DIN EN 50178
The maximum inrush current is 130 A
Functional plug-in bridges
The maximum power consumption under the rated condition is 0.43 W
Test voltage Coil/contact 4 kV AC (50 Hz, 1 minute, coil/contact)
Rated insulation voltage 250 V AC
Rated overvoltage 6 kV
Coil side
Rated input voltage UN 24 V DC
Input voltage range 20.2 V DC ... 33.6 V DC （20 °C）
Typical input current at UN is 18 mA
Typical response time is 8 ms
Typical release time is 10 ms
Coil voltage 24 V DC
Protection circuits polarity protection; Polarity protection diodes
spare diodes; Freewheeling diodes
The operating voltage is displayed with a yellow LED
handoff
Contact Type: 1 N/O contact
Switch contact type Single contact
Drive and function monostability
Drive (Polarity) Polarization
Contact material AgSnO2
Maximum switching voltage 250 V AC/DC (When the voltage between the same terminal blocks of two adjacent modules is greater than 250 V (L1, L2, L3), a bulkhead PLC-ATP must be used. FBST 8-PLC… Or... FBST 500… for equipotential bridging)
Minimum switching voltage 12 V (100 mA)
Limit continuous current to 6 A
10 A (if terminals 13, 14 and BB are shorted)
Maximum start-up current 80 A (20 ms)
130 A (peak, capacitive load, 230 V AC, 24 μF)
Minimum switching current 100 mA (12V)
Maximum power rating (resistive load) 144 W (24 V DC)
58 W (can be used for 48 V DC)
48 W (for 60 V DC)
50 W (can be used for 110 V DC)
80 W
85 W （250 V DC）
1500 VA (can be used for 250VAC)
Bridge power rating (resistive load) 240 W (24 V DC.) This value applies if terminals 13 and 14 as well as terminals BB are shorted)
2500 VA （250 V AC。 This value applies if terminals 13 and 14 as well as terminals BB are shorted)
Minimum on-off capacity 1200 mW
Switching capacity 2 A (at 24 V, 13 DCs)
0.2 A (at 110 V, 13 DCs)
0.2 A at 250 V, 13 DCs
6 A (at 24 V, AC15)
6 A (at 120 V, AC15)
6 A (at 250 V, AC15)
Connection: Push-in connection
Stripping length 10 mm
Rigid conductor cross-section 0.14 mm² ... 2.5 mm²
Flexible conductor cross-section 0.14 mm² ... 2.5 mm²
0.2 mm² … 2.5 mm² (single sleeve)
2x 0.5 mm² … 1 mm² (TWIN sleeve)
Attachable guide cross-section AWG 26 ... 14
Mounting Type: DIN rail mounting
Assembly Instructions Arrangement without spacing
Installation Position Any
All suppliers of 76 Technology have been strictly audited to ensure that all sources of goods come from manufacturers or formal agents. Our self-confidence stems from our strict requirements for product quality, adhere to the original **, fake one pay ten, if there is a demand, welcome to consult the delivery date and price, we will select the best quotation for you in many channels, 76 technology multi-brand one-stop procurement, save you time, worry, money.
The above is the Germany brand Phoenix relay module PLC-RPT- 24DC/ 1IC/ACT - 2900298 products, the purpose of 76 technology is to survive by quality, develop by reputation, and eternity by service, give us a chance, and give you a surprise.
|
More on that
|
Phoenix/Phoenix Single relay with manually operated locking - REL-OR2/L- 24AC/2X21 - 2903690
Pluggable octal relay with power contacts, 2PDT, test button, mechanical switch position display, coil voltage 24V AC
size
Width 35 mm
Height 35 mm
Depth 54.4 mm
Environmental conditions
Ambient temperature (operating) -40 °C ... 55 °C
Ambient temperature ...
|
|
Phoenix/Phoenix hybrid relay EMG 22-REL/KSR-G 24/TRN35 - 2952350
Relay module with miniature switching relay with integrated NPN transistor control, low control current, contact (AgNi): medium to large load, 1PDT, rated control voltage 24V DC
advantage
Low control current (module B), 0.5 mA depending on the model
Between the coil and the contacts ...
|
|
Phoenix/Phoenix relay module PLC-RSC-12DC/21/EX - 2909522
PLC-INTERFACE, consisting of DIN rail mountable, 6.2 mm base terminal with screw connection and plug-in miniature relay with 6 A power contact, 1 changeover contact, 12 V DC input voltage. Certified according to ATEX/IECEx (Zone 2) and Ex Area Class I, Zone 2 ...
|
|
Phoenix/Phoenix Single relay with manually operated locking - REL-MR-110DC/21HC/MS - 1012737
Plug-in miniature relay with power contact, 1 changeover contact, test key, mechanical switch position indicator, status LED, freewheeling diode, polarity A1+, A2-, input voltage 110 V DC
advantage
The strap can detect manual operation
Integrated status LEDs
Switching current max. 16 A ...
|
|
Phoenix/Phoenix relay module PLC-RPT- 12DC/21HC 2900290
The PLC-INTERFACE is suitable for high continuous currents and includes the PLC-BPT.../21 HC base terminal with plug-in connection with plug-in miniature relay for mounting on the DIN rail NS 35/7.5 with a limit continuous current of up to 10 A, 1 PDT, input voltage 12 V DC
advantage
...
|
|
RIF-1-RSC-LV-230AC/2X21 relay module from Phoenix/Phoenix - 2903347
Prefabricated relay modules with screw connections, including: relay bases, power contact relays, pluggable display/interference suppression modules, and brackets. Contact type: 2 changeover contacts. Input voltage: 230 V AC
The maximum power consumption under rated conditions is 1.38 W
Test voltage ...
|
|
Phoenix/Phoenix Single relay with manually operated locking - REL-MR- 24DC/21/MS - 2909642
Plug-in miniature power relay with power contact, 1 changeover contact, manual operation, 24 V DC input voltage
size
Width 5 mm
Height 28 mm
Depth 16 mm
Environmental conditions
Ambient temperature (operating) -40 °C ... 85 °C
Ambient temperature (storage/transportation)
|
|
Phoenix/Phoenix relay module RIF-2-RPT-LV-24AC/2X21 2903313
Pre-assembled relay modules with plug-in connections, including: relay bases, high-power contact relays, plug-in display/suppressor modules and brackets. Contact type: 2 PDT. Input voltage: 24 V AC
The maximum power consumption under rated conditions is 1.58 W
Test voltage (coil/contact ...
|
|
Phoenix/Phoenix relay module EMG 10-REL/KSR-230/ 1-LC AU - 2964416
Relay module with solid-state miniature electromagnetic relay, gold-plated contacts for small loads, 1 NO contact, input voltage 230 V AC/DC
Advantages: Integrated input module and interference suppression module
Maximum power consumption under rated conditions is 1.1 W
Test voltage (coil ...
|
|
Phoenix/Phoenix relay module EMG 22-REL/KSR-230/21 - 2952855
Relay module with solid state miniature electromagnetic relay, contact (AgNi): medium to large load, 1PDT, input voltage 230 V AC/DC
advantage
Secure isolation between coil and contact in accordance with DIN EN 50178
Integrated input module and interference suppression module
Rated ...
|
|
Relay module with manually operated locking - PLC-RSC-120UC/21-21/MS - 2910505
PLC-INTERFACE, including relay base and pluggable power contact relay (with manual operation and integrated status LED), screw connection, 2 changeover contacts, input voltage: 120 V AC / 110 V DC
size
Width 14 mm
Height 80 mm
Depth 104 mm
...
|
|
Phoenix/Phoenix relay module PLC-RPT-230UC/21-21/EX - 2909516
PLC-INTERFACE, consisting of DIN rail mounting, 14 mm base terminal with plug-in connection and plug-in relay with power contact, 2 changeover contacts, 230 V AC/220 V DC input voltage. It has been approved according to the requirements of ATEX/IECEx (Zone 2) and Ex Area Class I, Zone 2 ...
|
|
Phoenix/Phoenix relay module PLC-RSC-12DC/1/SSI-1094760
PLC-INTERFACE, CONSISTING OF SCREW-CONNECTED BASE TERMINALS AND "HOT" PLUGGING MINIATURE RELAYS AS WELL AS INTERNAL AMPLIFIER CIRCUITRY AND A SUITABLE AUXILIARY POWER SUPPLY FOR WEAK SIGNAL SOURCES, 1 NO NO U, 12 V DC RATED INPUT VOLTAGE
The maximum power consumption under the rated condition is 0.22 W
Electricity...
|
|
Relay module with manually operated locking - PLC-RSC- 24DC/21AU/MS - 2909655
PLC-INTERFACE, INCL. PLC-BSC.../21 BASE TERMINAL, SCREW CONNECTION, PLUG-IN MINIATURE RELAY WITH MULTI-LAYER GOLD-PLATED CONTACTS AND MANUAL OPERATION, 1 CO CONTACT, 24 V DC INPUT VOLTAGE
size
Width 6.2 mm
Height 80 mm
Depth 94 ...
|
|
Phoenix/Phoenix relay modules EMG 22-REL/KSR-230/21/AU - 2949295
Relay module with solid-state miniature electromagnetic relay, contacts (AgNi+Au): small to large loads, 1PDT, input voltage 230V AC/DC
advantage
Secure isolation between coil and contact in accordance with DIN EN 50178
Integrated input module and interference suppression module
Rated ...
|
|
Phoenix/Phoenix relay modules EMG 17-REL/KSR-W230/21-21-LC - 2940430
Relay module with solid-state miniature electromagnetic relay, contact (AgNi): medium to large loads, 2PDT, input voltage 230 V DC
advantage
Secure isolation between coil and contact in accordance with DIN EN 50178
Integrated input module and interference suppression module
Rated ...
|
|
Relay module with manually operated locking - PLC-RSC- 48DC/21HC/MS - 2910516
PLC-INTERFACE, including relay base and pluggable power contact relay with manual operation, integrated status LEDs and freewheeling diode, screw connection, 1 changeover contact, input voltage: 48 V DC
size
Width 14 mm
Height 80 mm
Depth 104 mm
...
|
|
Phoenix/Phoenix Single relay with manually operated locking - REL-MR - 24DC/21 - 2961105
Plug-in miniature power relay with power contacts, 1 PDT, input voltage 24 V DC
advantage
Secure isolation between coil and contact in accordance with DIN EN 50178
Depending on the model, the maximum degree of protection up to RT III (wash-resistant)
The maximum contact power is 6 A
size
...
|
|
RIF-0-RSC-24DC/21 relay module from Phoenix/Phoenix - 2903374
Prefabricated relay modules with screw connections, including relay bases with ejection devices and high-power contact relays. Contact type: 1 changeover contact. Input voltage: 24 V DC
The maximum power consumption under the rated condition is 0.22 W
Test voltage coil/contact 4 kVrms ...
|
|
Phoenix/Phoenix Single Relay REL-PR-BL-220DC/4X21 - 1157968
"Hot" plugging power relay, basic, 4 PDTs, status display: LED green, input voltage: 220 V DC
Product Type: Single relay
Mode of operation 100% working factor
Mechanical life approx. 107 switching cycles
Test voltage Coil/contact 2 kVrms (50 Hz ...
|
|
Contact
working hours
