PLC-INTERFACE, INCLUDING RELAY BASE AND PLUGGABLE MULTI-LAYER GOLD CONTACT RELAY WITH MANUAL OPERATION AND INTEGRATED STATUS LED, SCREW CONNECTION, 2 CO CONTACTS, INPUT VOLTAGE: 24 V AC/DC
size
Width 14 mm
Height 80 mm
Depth 104 mm
Environmental conditions
Ambient temperature (operating) -20 °C ... 60 °C
Ambient temperature (storage / transport) -20 °C ... 85 °C
Maximum height ≤ 2000 m
Protection class RT II (relay)
IP20 (Relay Base)
≥ IP54 (mounting position)
Coil side
Rated input voltage UN 24 V AC/DC
Typical input current at UN is 18 mA
Typical response time 3 ms ... 15 ms
Typical release time range 3 ms ... 15 ms
Coil voltage 24 V DC
Protection circuit Bridge rectifier Bridge rectifier
The operating voltage is displayed with a yellow LED
Contact side
Contact Type: 2 changeover contacts
Switch contact type Single contact
Contact material AgNi, hard gold plating
The maximum switching voltage is 30 V AC
36 V DC
Minimum switching voltage 12 V (1 mA)
Minimum switching current 1 mA (12V)
The maximum starting current is 50 mA
Limit continuous current to 50 mA
Contact surface (with destructible gold plating)
Precautions If the plating is damaged, the following values can be applied
Maximum switching voltage 250 V AC/DC
The minimum switching voltage is 12 V
Limit continuous current to 6 A
Maximum start-up current 12 A (20 ms)
The minimum switching current is 10 mA
Maximum power rating (resistive load) 192 W (24 V DC)
62 W （48 V DC）
42 W （60 V DC）
55 W （110 V DC）
66 W （220 V DC）
2000 VA （250 V AC）
Switching capacity 1 A (24 V, DC13)
1.5 A （230 V, AC15）
overview
Test voltage 4 kV AC (50 Hz, 1 minute, coil/contact)
2.5 kV AC (50 Hz, 1 minute, CO contact/CO contact)
Mode of operation 100% working factor
Flammability rating according to UL 94 V0 (enclosure)
Mechanical life 5x106 switching cycles
Installation Position Any
Assembly Instructions Arrangement without spacing
Connect your data
Connection Name Coil Side
Connection: Screw connection
Stripping length 8 mm
Thread M3
Rigid conductor cross-section 0.14 mm² ... 2.5 mm²
Flexible conductor cross-section 0.14 mm² ... 2.5 mm²
0.2 mm² … 2.5 mm² (single sleeve)
2x 0.5 mm² … 1.5 mm² (TWIN sleeve)
Attachable guide cross-section AWG 26 ... 14
Connect to data2
Connection Name Contact Side
Connection: Screw connection
Stripping length 8 mm
Thread M3
Rigid conductor cross-section 0.14 mm² ... 2.5 mm²
Flexible conductor cross-section 0.14 mm² ... 2.5 mm²
0.2 mm² … 2.5 mm² (single sleeve)
2x 0.5 mm² … 1.5 mm² (TWIN sleeve)
Attachable guide cross-section AWG 26 ... 14
All suppliers of 76 Technology have been strictly audited to ensure that all sources of goods come from manufacturers or formal agents. Our self-confidence stems from our strict requirements for product quality, adhere to the original **, fake one pay ten, if there is a demand, welcome to consult the delivery date and price, we will select the best quotation for you in many channels, 76 technology multi-brand one-stop procurement, save you time, worry, money.
The above is the Germany brand Phoenix/Phoenix relay module with manual operation locking function - PLC-RSC- 24UC/21-21AU/MS - 2910508 products, the purpose of 76 technology is to survive by quality, develop by reputation, and eternal by service, give us a chance and give you a surprise.
|
More on that
|
Phoenix/Phoenix relay module PLC-RSC-125DC/21AU - 2980034
PLC-INTERFACE, INCL. PLC-BSC.../21 BASE TERMINAL, SCREW CONNECTION, WITH PLUG-IN MINIATURE MULTI-LAYER GOLD-PLATED CONTACT RELAY FOR MOUNTING ON DIN RAIL NS 35/7.5, 1 PDT, input voltage 125 V DC
The maximum power consumption under rated conditions is 0.38 W
Test Electricity ...
|
|
Relay module with manually operated locking - PLC-RPT- 24UC/21HC/MS - 2910531
PLC-INTERFACE, including relay base and pluggable power contact relay with manual operation and integrated status LED, Push-in connection, 1 changeover contact, input voltage: 24 V AC/DC
size
Width 14 mm
Height 80 mm
Depth 104 mm
Environmental Strip ...
|
|
Phoenix/Phoenix relay modules - PLC-RSC- 24DC/ 1AU/MS/SEN - 2909663
The PLC-INTERFACE is suitable for input functions, including the PLC-BSC.../SEN base terminals, screw connection, plug-in miniature relay with multi-layer gold-plated contacts and manual operation, 1 NO contact, 24 V DC input voltage
size
Width 6.2 ...
|
|
Phoenix/Phoenix relay modules EMG 10-REL/KSR-120/ 1-LC -2964432
Relay module with solid-state miniature electromagnetic relay, contact (AgNi): medium to large loads, 1 NO contact, input voltage 120 V AC/DC
Advantages: Integrated input module and interference suppression module
The maximum power consumption under rated conditions is 0.6 W
Test voltage (coil ...
|
|
Phoenix/Phoenix relay module DEK-REL- 24/O/1 - 2941154
Relay module with solid state miniature relay, contacts (AgNi+Au): small to medium loads, 1 NO contact, input voltage 24V AC/DC, mountable on NS 35/7.5, module thickness 6.2mm, rotary
advantage
Reduced costs due to the elimination of N-terminals
Save up to ...
|
|
REL-IR4/DP-220DC/4X21 - 2905728
Plug-in industrial relay with 4 PDT contacts and manual operation, 220 V DC voltage coil with an operating range of 0.6 ... 0.8 x UN (at 23 °C)
Coil side
Rated input voltage UN 220 V DC
Input voltage range 171.6 V DC ... 429 V DC
Take the UN as ...
|
|
Phoenix/Phoenix Single Relay REL-MR- 24DC/1IC - 2961341
Plug-in miniature power relay with power contacts for high impulse currents up to 130 A peak, 1 NO contact, input voltage: 24 V DC
advantage
Secure isolation between coil and contact in accordance with DIN EN 50178
Depending on the model, the maximum degree of protection up to RT III ...
|
|
Phoenix/Phoenix relay modules RIF-1-RSC-LV-120AC/1X21 -2903356
Prefabricated relay modules with screw connections, including: relay bases, power contact relays, pluggable display/interference suppression modules, and brackets. Contact type: 1 changeover contact. Input voltage: 120 V AC
Maximum power consumption under rated conditions is 0.96 W
Test voltage ...
|
|
REL-MR-12DC/21HC/EX - 2908821 single relay
Plug-in miniature power relay, RT III sealed, with power contacts, 1 changeover contact, input voltage: 12 V DC, in combination with the corresponding PLC base, is certified according to the requirements of ATEX/IECEx (Zone 2) and Ex Zone I, Class 2.
Advantages: Cutting up to 16 A ...
|
|
Phoenix/Phoenix relay module PLC-RSC- 24DC/ 1ICT/ACT - 1078680
The PLC-INTERFACE is suitable for high inrush currents and consists of PLC-BSC.../1 IC/ACT base terminals with screw connection and pluggable miniature relays, can be mounted on the DIN rail NS 35/7,5, with a maximum inrush current of up to 800 A, 1 NO contact, 24 V DC input voltage
Excellent...
|
|
Phoenix/Phoenix relay module PLC-RPT- 24DC/21AU - 2900306
PLC-INTERFACE, incl. PLC-BPT.../21 base terminal with plug-in connection with plug-in miniature multi-layer gold-plated contact relay for mounting on DIN rail NS 35/7.5, 1 PDT, input voltage 24 V DC
advantage
Low-profile design
Implemented via V8 adapter with ...
|
|
Phoenix/Phoenix relay module PLC-RSC- 24DC/ 1AU/SEN - 2966317
The PLC-INTERFACE is suitable for input functions, including PLC-BSC.../SEN base terminals with screw connection with plug-in miniature multilayer gold-plated contact relays for mounting on DIN rail NS 35/7.5, 1 NO contact, input voltage 24 V DC
advantage
Maximum savings of 60 ...
|
|
Phoenix/Phoenix relay modules PLC-RSC-230AC/21HC/SO46/HI-1079402
The PLC-INTERFACE consists of PLC-BSC.../21HC/SO46/HI base terminals with screw connection and Push-in miniature relays for high continuous currents, 1 changeover contact, rated input voltage of 230 V AC, defined activation and deactivation thresholds
The most ...
|
|
Phoenix/Phoenix relay module RIF-0-RPT-12DC/ 1 - 2903362
Pre-assembled relay modules with plug-in connections, including: relay base (with pop-up) and high-power contact relays. Contact type: 1 NO contact. Input voltage: 12 V DC
Maximum power consumption of 0.19 W under rated conditions
Test voltage coil/contact 4 kVrms ...
|
|
Phoenix/Phoenix Single relay with manually operated locking - REL-MR-230AC/21-21/MS - 2987972
Pluggable miniature relay with power contacts, 2 PDTs, test key, mechanical switch position display, status LED, coil voltage 230VAC
advantage
The strap can detect manual operation
DC model with freewheeling diode
Integrated status LEDs
The maximum switching current is 16A
Mechanical switch position ...
|
|
Phoenix/Phoenix relay module PLC-RSC- 24UC/21AU - 2966278
PLC-INTERFACE, incl. PLC-BSC.../21 base terminal, screw connection, with plug-in miniature multi-layer gold-plated contact relay for mounting on DIN rail NS 35/7.5, 1 PDT, input voltage 24 V AC/DC
The maximum power consumption under rated conditions is 0.26 W
Test...
|
|
Phoenix/Phoenix relay module PLC-RPT- 24UC/21-21AU/RW - 2900349
PLC-INTERFACE for rail applications, including base terminals, with plug-in connection and plug-in miniature multi-layer gold-plated contact relays, range: 0.7 x UN to 1.25 x UN, temperature class TX: -40 °C to +70 °C, 2 PDTs, input voltage 24 V DC
Excellent...
|
|
Phoenix/Phoenix Single relay with manually operated locking - REL-IR2/LDP-125DC/2X21 - 2903664
Pluggable industrial relay with power contacts, 2 PDTs, test button, status LED, freewheeling diode, mechanical switch position display, polarity: A1+, A2-, input voltage: 125 V DC
size
Width 21.2 mm
Height 27.5 mm
Depth 35.6 mm
Environmental conditions
...
|
|
Phoenix/Phoenix relay PLC-RSC-230UC/21AU/MS - 2909660
PLC-INTERFACE, incl. PLC-BSC.../21 base terminal, screw connection, plug-in miniature relay with multi-layer gold-plated contacts and manual operation, 1 changeover contact, 230 V AC/220 V DC input voltage
The maximum power consumption under rated conditions is 0.74 W
...
|
|
Relay module with manually operated locking - PLC-RPT-120UC/21-21/MS - 2910522
PLC-INTERFACE, including relay base and pluggable power contact relay with manual operation and integrated status LED, Push-in connection, 2 changeover contacts, input voltage: 120 V AC / 110 V DC
size
Width 14 mm
Height 80 mm
Depth 104 mm ...
|
|
Contact
working hours
