Siemens 6ES7155-5AA00-0AA0 ET 200MP

Product type marking		IM 155-5 PN Basic
Hardware functional status		FS01
Firmware version		V4.0.0
VendorID		0x002A
Device Tag (DeviceID)		0x0312
Product features
● I&M data		Be; I&M0 to I&M3
Comes with a package
● STEP 7 TIA port, configurable / integrated, self-versioning		V14 with HSP 0187
● STEP 7 Configurable / Integrated, self-version		V5.5 SP3 / -
● PROFINET version GSD version / GSD revision or above		v2.3 / -
Configure control
Through valid data		not
Through data groups		not
Supply voltage
Rating (DC)		24 V
Allowable Range, Lower Limit (DC)		20.4 V
Allowable Range, Upper Limit (DC)		28.8 V
Reverse polarity protection		be
Short-circuit protection		be
Power supply and voltage break jumper
● Power outage/power off bridging time		5 ms
Input current
Current Consumption (Rating)		1 A
Current consumption, maximum		1.7 A
Turn-on current, maximum		2.8 A
I²t		0.04 A²·s
power
Feed power on the backplane bus		14 W
Power loss
Power loss, typical		3 W
Address range
The address space of each module
● The address space of each module, the maximum value		64 byte; Each input/output
The address space for each site
● Address space per site, maximum		64 byte; Each input/output
Hardware expansion
Integrated power supply		be
Plug-in system power supply to the left of the IM		not
The number of segmented power supplies allowed		1
Component carriers
● Components of each component carrier, maximum		12; Peripheral device modules
Submodules
● The number of sub-modules per site, the maximum		108; 9 submodules/peripheral modules
interface
Number of PROFINET interfaces		1; 2 ports (switches) RJ45
1. Interface
Physical interfaces
● Number of ports		2
● Integrated switches		be
● RJ 45 (Ethernet)		be
● BusAdapter (PROFINET)		not
agreement
● PROFINET IO devices		be
● Gas-liquid redundancy		be
Physical interfaces
RJ 45 (Ethernet)
● Transmission mode		PROFINET, 100 Mbit/s, full duplex (100BASE-TX)
● 100 Mbit/s		be
● Auto-negotiation		be
● Automatic crossing		be
agreement
PROFINET IO devices
serve
— Isochronistic mode		not
— Open IE communication		be
— IRT		not
— PROFIenergy		not
— Start by priority		not
— Shared devices		be
— The maximum number of IO controllers in a shared device		2
Redundancy mode
● MRP		be
● MRPD		not
● PROFINET system redundancy (S2)		not
Open IE communication
● TCP/IP		be
● SNMP		be
● LLDP		be
Isochronistic mode
Beat Sync Run (Application to Port Sync)		not
equidistance		not
Alarm/Diagnostic/Status Information
Status display		be
alarm		be
Diagnostic features		be
Diagnostics display LEDs
● RUN LED		Be; Green LED
● ERROR LED		Be; Red LED
● MAINT LED		Be; Yellow LED
● LINK TX/RX connection display		Be; 2x yellow-green LEDs
Galvanic isolation
between the backplane bus and the electronics		not
between PROFINET and all other circuits		be
between the power supply and all other circuits		not
Permissible potential difference
between different circuits		Safe extra-low voltage SELV
insulation
Insulation test, use		707 V DC (test type)
Standards, Licenses, Certificates
Network load level		2
Environmental requirements
The ambient temperature during operation
● Horizontal installation, minimum		0 °C
● Horizontal installation, maximum		60 °C
● Vertical installation, minimum		0 °C
● Vertical installation, maximum		40 °C
size
width		35 mm
height		147 mm
depth		129 mm
weight
Weight, approx		236 g

Siemens 6ES7155-5AA00-0AA0 ET 200MP

Sections viewed

Contact

working hours