Introduction: GP-UPS series online uninterruptible power supply is an online UPS model with power frequency three in and three out or three in and out of line. This series of UPS adopts the high-frequency double-conversion structure of output isolation transformer and advanced all-digital control technology to achieve stable, clean and uninterruptible power supply output. At the same time, it also provides a variety of communication solutions and a friendly man-machine interface, which is convenient for users to set up and monitor the machine. The communication section offers MODBUS, RS232 as well as expandable smart slots. This series of UPS system is mainly composed of rectifier module and inverter module, AC to DC and then to AC double conversion circuit, static bypass, maintenance bypass, battery charge and discharge circuit and other main modules. Compared with HP-UPS series products, the built-in isolation transformer of GP-UPS series products has the obvious advantages of strong anti-high-frequency interference ability, strong anti-overload ability, effective reduction of zero-ground voltage and high reliability. This series of UPS can provide reliable power supply for medium and large networks, data centers, centralized power supply of buildings, industrial plants and mines, and other applications.
Features:
It adopts high-performance DSP chip (32-bit 150MHz, independent multiplier) all-digital THDV control
Intelligent fan speed control, under redundant or half-load conditions, the operating noise of the whole machine is less than 60db (in line with YD/T1095-20081 level)
Optimized air duct and heat dissipation: Improved efficiency
It adopts 6 temperature detection sensors and has an early warning function
The signal line/electronic line is independently routed, and the circuit board adopts three-proof protection to improve the reliability of operation
It has a cold start function
Protection function for installation errors (misconnection of input and output, reverse connection of battery)
It satisfies the non-linear instantaneous projection without turning bypass at full load
Battery switch detection
Product parameters
input
Rated voltage: 3x380VAC/400VAC (3 phase + N wire: + ground wire)
Voltage range: 304VAC - 456VAC
Frequency range: 50Hzt5Hz (soil 10%)
output
Rated voltage: 3x380VAC/400VAC (3-phase+N)
Wiring: Three-phase 5-wire (3-phase + N + ground)
Output waveform: Pure sine wave
Output voltage regulation accuracy
Steady-state: +1%
Dynamic: 5% of Soil
Output frequency: 50Hz
Output Frequency Accuracy: +1%
Frequency Tracking Range: t5Hz (equivalent to bypass operating range)
Frequency tracking speed: 1-2Hz/sec
Output power: 0.8
Output current peak factor: 3:1
Output Waveform Distortion: <2% (Linear Load); <4% (non-linear load)
Dynamic voltage transient range: 0%-> 100%->0% (R load) <+5% ; 20%-> 100%->20% (R load) soil 3%
Conversion time: 0 ms
Overload capacity: 0%-110% sustainable operation; 110% - 150% can last 10 - 1 minute; > 160% lasts 200 milliseconds
Short-circuit capability: 60-100 ms
Transient response time: <5 ms
bypass
By line: 3x380VAC/400VAC (3-phase +N)
Input voltage range: 3x 380VAC/400VAC/415VAC (3 phase + N line)
Overload Capacity: 1.5 in – 1.8 in 1 hour to 30 seconds
Short Circuit Capability:1. 8In - > 2 0 thousand 30 seconds - in 200 milliseconds
The company respects the enterprise spirit of "practicality, hard work and responsibility", and creates a good corporate environment with integrity, win-win, and business philosophy, and takes a new management model, perfect technology, thoughtful service, and excellent quality as the foundation for survival. We always adhere to: customer first, serve customers attentively, and insist on impressing customers with their own services. Always adhering to the business philosophy of "integrity, win-win", relying on excellent prices, excellent quality, fast delivery and pre-sales consultation and after-sales service to win the trust of our customers.
This article introduces CHINT/CHINT uninterruptible power supply GP-UPS series cabinet industrial machine products, if you are interested in CHINT/CHINT uninterruptible power supply, please also contact our customer service, we look forward to your call, hope our technology and service can bring you a better experience.
|
More on that
|
CHINT/CHINT CJ40 Series AC Contactor CJ40-200
CJ40 series AC contactor (hereinafter referred to as contactor) is mainly used for switching and breaking circuits in power systems with AC 50Hz or 60Hz, rated voltage to 660V or 1140V, and current to 1000A.
|
|
CHINT/CHINT Terminal Block-JCUK Series
JCUK series is suitable for wire connection in circuits with AC 50Hz or 60Hz, rated voltage to 1000V and rated cross-sectional area to 150mm2. It is installed on TH35 rails.
Comply with standards: GB/T 14048.7, IEC 60947-7-1.
This article introduces the CHINT/CHINT Terminal Blocks - ...
|
|
CHINT/CHINT ND9 signal light
ND9 signal light is suitable for AC 50Hz/60Hz, rated voltage up to 230V, DC voltage up to 230V circuit control system. It is used as an indication signal, preset signal, accident signal and other indication of telecommunications, electrical and other lines.
Standards: GB/T 14048.5, IEC 60947-5-1 ...
|
|
CHINT/CHINT NXA series universal circuit breaker
Shell Frame Class (A): 1600, 2000, 3200, 4000, 6300A
● Two kinds of breaking capacity: N, H
● Rated voltage Ue (VAC): 380/400/415, 440/525/690V
● Number of poles: 3 or 4 poles (In=6300A only has 3 poles)
● Installation: drawer type or fixed type ...
|
|
CHINT/CHINT AC Contactor CJX2 Series has a mechanical life of 10 million times
Introduction: CHINT/CHINT AC contactor CJX2 series (hereinafter referred to as contactor) is mainly used for AC 50Hz (or 60Hz), rated working voltage to 690V, in the AC-3, 400 (380) V use category rated working current to 95A circuit, for long-distance connection and breaking of circuits, frequency ...
|
|
CHINT/CHINT AX-5 auxiliary contacts
The AX-5 auxiliary contact is suitable for AC 50Hz, the agreed heating current to 6A, the rated voltage to 415V or the DC rated voltage to 130V, and it is assembled with the NL1 residual current action circuit breaker for the signal indication of the long-distance circuit breaker.
Conform to the standard: GB/T 14048.5, ...
|
|
CHINT/CHINT NCH8G Household AC Contactor NCH8G-40/22
NCH8G series household AC contactor (hereinafter referred to as contactor) is mainly suitable for AC 50Hz (or 60Hz), rated working voltage to 400V rated working current to 63A circuit, control household appliances and similar uses of low-inductance and micro-inductance loads; It can also be used to control household ...
|
|
CHINT/CHINT NBHLU-63 residual current action circuit breaker
NBHLU-63 residual current action circuit breaker is suitable for AC 50Hz, rated voltage 230V power distribution and control system, rated current to 63A in the line to play leakage, overload and short circuit protection, at the same time, this series of products have the corresponding function of surge protector.
The product conforms to GB/T 16917 ...
|
|
CHINT/CHINT NXBLE-125 residual current action circuit breaker
CHINT/CHINT NXBLE-125 residual current action circuit breaker
Rated current (In): 63A, 80A, 100A, 125A (1P+N, 2P);
Rated Residual Operating Current (IOn) : AC type: 0.03A, 0.05A, 0.075A, 0.1A, 0.3A; Type A: 0.03A, ...
|
|
CHINT AX-X1H auxiliary contact
AX-X1H auxiliary contact is mainly used in lines with AC rated voltage to 415V or DC rated voltage to 130V, and is assembled with NBH-40 and NBH-63 series miniature circuit breakers for signal indication of long-distance circuit breakers.
The auxiliary contact is an accessory product.
|
|
CHINT/CHINT New Series NB5 Accessories
SHT-B5 shunt tripper (hereinafter referred to as tripper) is mainly used for matching with NB5 series circuit breakers, and is suitable for long-distance shunt tripping operation in lines with AC 50Hz and rated voltage to 415V;
AX-B5 auxiliary contact is mainly used for AC 50Hz, rated heating current to 6A, rated ...
|
|
CHINT/CHINT HZ12 Series Combination Switch (Power Cut-off Switch) HZ12-40
HZ12 series power cut-off switch is suitable for AC 50Hz or 60Hz, voltage to 550V circuit, as the power supply cut off and on.
Comply with standards: GB/T 14048.3, IEC 60947-3.
Ith A:40
Ui A:550
Ue V:380
Ie/A(AC-23A): 40
...
|
|
CHINT/CHINT DZ15 series plastic case circuit breaker
DZ15 series plastic shell circuit breaker (hereinafter referred to as circuit breaker) is suitable for AC 50Hz, rated voltage of 380V, rated current to 100A circuit, as power distribution, motor overload and short circuit protection, but also as line infrequent conversion and motor infrequent start.
...
|
|
CHINT/CHINT NM5 Thermomagnetic Molded Case Circuit Breaker
CHINT Xinrui NM5 series plastic case circuit breaker is suitable for AC 50/60Hz, rated voltage AC690V and below, rated current from 16A to 1000A
circuits. As the rated current of on, breaking and bearing, it can be overloaded, short-circuited and under-voltage in the line and electrical equipment.
|
|
CHINT/CHINT NCH8G Household AC Contactor NCH8G-20/20
NCH8G series household AC contactor (hereinafter referred to as contactor) is mainly suitable for AC 50Hz (or 60Hz), rated working voltage to 400V rated working current to 63A circuit, control household appliances and similar uses of low-inductance and micro-inductance loads; It can also be used to control household ...
|
|
CHINT/CHINT Terminal Appliance —NH2-125 Disconnector
NH2-125 disconnector is mainly used as the main switch in the terminal combination electrical appliances, suitable for AC 50Hz, rated voltage to 400V in the power distribution and control circuit, can also be used to control motors, low-power electrical appliances and lighting, widely used in industrial and mining enterprises, high-rise buildings, commercial and household ...
|
|
CHINT/CHINT CJ20 Series AC Contactor CJ20-63
CJ20 series AC contactor (hereinafter referred to as contactor) is mainly used in AC 50Hz (or 60Hz), rated working voltage to 660V, rated working current to 630A, for long-distance switching and breaking circuits, and can be combined with appropriate thermal overload relays.
|
|
CHINT/CHINT CJX1-K Series Contactors The operating frequency is 1200 hours
Introduction: CJX1-K series AC vacuum contactor (hereinafter referred to as contactor), mainly used for AC 50Hz-60Hz, rated insulation voltage of 1000V, rated working voltage of 380V under the AC-3 use category of rated working current to 820A in the circuit, for long-distance connection and disconnection ...
|
|
CHINT/CHINT NCH8G Household AC Contactor NCH8G-20/01
NCH8G series household AC contactor (hereinafter referred to as contactor) is mainly suitable for AC 50Hz (or 60Hz), rated working voltage to 400V rated working current to 63A circuit, control household appliances and similar uses of low-inductance and micro-inductance loads; It can also be used to control household ...
|
|
CHINT/CHINT NXBF-125 plastic case circuit breaker
NXBF-125 plastic shell circuit breaker is suitable for AC 50Hz, rated voltage 230V/400V, rated current to 125A in the line, for overload and short circuit protection, under normal circumstances, as the line of infrequent operation and conversion, can also be used as a disconnection line for line and equipment maintenance...
|
|