Panasonic standard amplifier PNP open collector transistor FX-101P-CC2

Panasonic standard amplifier PNP open-collector transistor FX-101P-CC2, maximum source current: 100 mA, applied voltage 30 V DC or less, residual voltage 1.5 V or less (at 100 mA source current)
Panasonic standard amplifier PNP open collector transistor FX-101P-CC2

project	content
Order product number	FX-101P-CC2
Model	FX-101P-CC2
Supply voltage	12~24V DC±10% pulsation P-P10% or less
Power consumption	Typical: 720 mW or less (24 V power supply voltage, 30 mA current consumption or less)
Power consumption	ECO mode: 600 mW or less (24 V power supply voltage, 25 mA current consumption or less)
output	PNP open-collector transistors
	・Maximum source current: 100mA
	・Applied voltage: 30V DC or less (between output and +V)
	・Residual voltage: 1.5 V or less (at 100 mA source current)
Output: Outputs the action	You can switch ON when the light is in or ON when the light is not in the SET mode
Output: Short-circuit protection	Equipped with
External inputs	PNP contactless input
	・Signal conditions
	High:+4V~+V DC (Inflow current 0.5~3mA)
	Low: 0~+0.6V DC or off
	・Input impedance: Approx. 10kΩ
Reaction time	Projection frequency: 0:250μs or less (factory state)
	The projection frequency is 1:450μs or less
	Beam frequency 2: 500μs or less
	Projection frequency 3: 600μs or less
How to set the sensitivity	2 points of teaching/limited teaching/automatic teaching
Working status indicator	Orange LED (lights up when ON is output)
Numeric value display	4-digit (green) + 4-digit (red) LCD display
Set the sensitivity fine-tuning function	Equipped with
Timer function	The on/off delay timer can be adjusted to be active or inactive
Timer function	[Timer time: 1ms, 5ms, 10ms, 20ms, 40ms, 50ms, 100ms, 500ms, 1,000ms]
Adjustable amount of light emitted	3 grades + automatic setting (from part produced in December, 2007)
Anti-jamming function	Equipped with adjustable active or inactive
Environmental resistance: The ambient temperature at which it is used	-10~+55°C (-10~+50°C when 4~7 units are installed closely, -10~+45°C when 8~16 units are installed closely) (note that condensation and freezing are not allowed), storage: -20~+70°C
Environmental resistance: Ambient humidity is used	35~85%RH, when stored: 35~85%RH
Environmental resistance: Use ambient illumination	Incandescent lamp: 3,000 Rx or less on the light-receiving surface
Environmental resistance: Withstand voltage	AC1,000V for 1 minute between all power connection terminals and housing
Environmental resistance: Withstand voltage	Note: The withstand voltage and insulation resistance values are only available for individual amplifier parts.
Environmental resistance: insulation resistance	A high-impedance meter based on 250 VDC between all power supply terminals and housings of 20 MΩ or more
Environmental resistance: insulation resistance	Note: The withstand voltage and insulation resistance values are only available for individual amplifier parts.
Environmental resistance: Vibration resistance	Frequency: 10~150Hz, double amplitude: 0.75mm, 2 hours each in the X, Y and Z directions
Environmental resistance: impact resistance	Acceleration: 98 m/s2 (approx. 10 G) 5 times each in the X, Y and Z directions
Projection Element (Modulated)	Red LED (Emission peak wavelength: 643nm)
Material	Enclosure cover: Polycarbonate
	Key switches: Polycarbonate
	Fiber Optic Lock Lever: PBT
Connection	Connector connectivity
Connection	Note: Models without "-CC2" at the end of the model name do not come with a connector cable (CN-14A-C2). Be sure to use the separately sold cable with connector CN-14A(-R)-C□, connector CN-14A, or Japan crimp terminal manufacturer (contact: SPHD-001T-P0.5, housing: PAP-04V-S).
Wiring length	The total length of the cable of 0.3mm2 or more can be extended to 100m
weight	Body weight: Approximately 15 g
weight	Package weight: about 75g
accessory	CN-14A-C2 (2m long cable with connector): 1 pc

Panasonic standard amplifier PNP open-collector transistor FX-101P-CC2, maximum source current: 100 mA, applied voltage 30 V DC or less, residual voltage 1.5 V or less (at 100 mA source current). 76 Technology with quality assurance, with excellent reputation, so that you are comfortable in the purchase, rest assured in use, 76 Technology, need your trust and support.

Panasonic standard amplifier PNP open collector transistor FX-101P-CC2

Sections viewed

Contact

working hours