PLC-INTERFACE, including relay base and pluggable power contact relay with manual operation, integrated status LEDs and freewheeling diode, Push-in connection, 2 changeover contacts, input voltage: 48 V DC
size
Width 14 mm
Height 80 mm
Depth 104 mm
Environmental conditions
Ambient temperature (operating) -20 °C ... 60 °C
Ambient temperature (storage / transport) -20 °C ... 85 °C
Maximum height ≤ 2000 m
Protection class RT II (relay)
IP20 (Relay Base)
≥ IP54 (mounting position)
Coil side
Rated input voltage UN 48 V DC
Typical input current at UN is 19 mA
Typical response time is 6 ms
Typical release time is 10 ms
Protection circuit: Bridge rectifier
The operating voltage is displayed with a yellow LED
Contact side
Contact Type: 2 changeover contacts
Switch contact type Single contact
Contact material AgNi
Maximum switching voltage 250 V AC/DC (When the voltage between the same terminal blocks of two adjacent modules is greater than 250 V (L1, L2, L3), a bulkhead PLC-ATP must be used. FBST 8-PLC… Or... FBST 500… for equipotential bridging)
Minimum switching voltage 12 V (10 mA)
Minimum switching current 10 mA (12V)
Maximum start-up current 12 A (20 ms)
Limit continuous current to 6 A
Maximum power rating (resistive load) 192 W (24 V DC)
62 W （48 V DC）
42 W （60 V DC）
55 W （110 V DC）
66 W （220 V DC）
2000 VA （250 V AC）
Switching capacity 1 A (24 V, DC13)
1.5 A （230 V, AC15）
overview
Test voltage 4 kVrms (50 Hz, 1 minute, coil/contact)
2.5 kVrms (50 Hz, 1 minute, CO contact/CO contact)
Mode of operation 100% working factor
Flammability rating according to UL 94 V0 (enclosure)
Mechanical life 5x106 switching cycles
Installation Position Any
Assembly Instructions Arrangement without spacing
Connect your data
Connection Name Coil Side
Connection: Push-in connection
Stripping length 8 mm
Rigid conductor cross-section 0.14 mm² ... 2.5 mm²
Flexible conductor cross-section 0.14 mm² ... 2.5 mm²
0.2 mm² … 2.5 mm² (single sleeve)
2x 0.5 mm² … 1 mm² (TWIN sleeve)
Attachable guide cross-section AWG 26 ... 14
Connect to data2
Connection Name Contact Side
Connection: Push-in connection
Stripping length 8 mm
Rigid conductor cross-section 0.14 mm² ... 2.5 mm²
Flexible conductor cross-section 0.14 mm² ... 2.5 mm²
0.2 mm² … 2.5 mm² (single sleeve)
2x 0.5 mm² … 1 mm² (TWIN sleeve)
Attachable guide cross-section AWG 26 ... 14
Standards and Specifications
Name Standards/Regulations
Standard/Procedure EN 50178
Rated insulation voltage 250 V AC
Rated overvoltage 6 kV
Insulation: Safety isolation, reinforced insulation
Pollution class 2
Overvoltage category III
All suppliers of 76 Technology have been strictly audited to ensure that all sources of goods come from manufacturers or formal agents. Our self-confidence stems from our strict requirements for product quality, adhere to the original **, fake one pay ten, if there is a demand, welcome to consult the delivery date and price, we will select the best quotation for you in many channels, 76 technology multi-brand one-stop procurement, save you time, worry, money.
The above is the Germany brand Phoenix relay module with manual operation locking function - PLC-RPT- 48DC/21-21/MS - 2910521 products, the purpose of 76 technology is to survive by quality, develop by reputation, and eternal by service, give us a chance and give you a surprise.
|
More on that
|
Phoenix/Phoenix relay module PLC-RSC-24DC/21/EX - 2909524
PLC-INTERFACE, consisting of DIN rail mounting, 6.2 mm base terminal with screw connection and plug-in miniature relay with 6 A power contact, 1 changeover contact, 24 V DC input voltage. Certified according to ATEX/IECEx (Zone 2) and Ex Area Class I, Zone 2 ...
|
|
Phoenix/Phoenix relay module RIF-2-RPT-LV-230AC/4X21/EX-2909739
Prefabricated relay modules include: relay base, plug-in function module, power contact relay and bracket, certified according to ATEX/IECEx (Zone 2) and Ex Zone Class I, Zone 2, Push-in connection, 4 PDTs, varistor, input voltage: 230 V AC
...
|
|
Phoenix/Phoenix relay modules EMG 10-REL/KSR-230/21-LC - 296438
Relay module with solid state miniature electromagnetic relay, contact (AgNi): medium to large load, 1PDT, input voltage 230 V AC/DC
The maximum power consumption under the rated condition is 1.15 W
Test voltage (coil/contact) 4 kV AC (50 Hz, 1 minute, coil/contact) ...
|
|
Phoenix/Phoenix Single relay with manually operated locking - REL-IR2/LDP-125DC/2X21 - 2903664
Pluggable industrial relay with power contacts, 2 PDTs, test button, status LED, freewheeling diode, mechanical switch position display, polarity: A1+, A2-, input voltage: 125 V DC
size
Width 21.2 mm
Height 27.5 mm
Depth 35.6 mm
Environmental conditions
...
|
|
RIF-2-RSC-LDP-24DC/4X21 - 2903320
Prefabricated relay modules with screw connections, including: relay bases, power contact relays, and brackets. Contact type: 4 changeover contacts. Input voltage: 24 V DC
Coil side
Rated input voltage UN 24 V DC
Input voltage range 19.2 V DC ... 30 V D ...
|
|
Relay module with manually operated locking - PLC-RPT-230UC/ 1AU/MS/SEN - 2909680
The PLC-INTERFACE is suitable for input functions, including PLC-BPT.../SEN base terminals with plug-in connection with plug-in miniature relays with multi-layer gold-plated contacts and manual operation, 1 normally open contact, 230 V AC/220 V DC input voltage
size
Width 6.2 ...
|
|
Phoenix/Phoenix relay module RIF-0-RSC-12DC/ 1AU - 2903365
Prefabricated relay modules with screw connections, including: relay base with ejection device and multi-layer gold-plated contact relays. Contact type: 1 NO contact. Input voltage: 12 V DC
Maximum power consumption of 0.19 W under rated conditions
Test voltage (coil/contact) 4 k ...
|
|
Phoenix/Phoenix relay modules DEK-REL- 24/1/AKT- 2964063
Relay module for actuators with solid state miniature relays, contacts (AgNi+Au): small to medium loads, 1 normally open contact, input voltage 24V AC/DC, mountable on NS 35/7.5, module thickness 6.2mm
advantage
Reduced costs due to the elimination of N-terminals
Most...
|
|
Phoenix/Phoenix single relay REL-MR-BL- 12DC/21HC - 1109537
Plug-in miniature power relay, basic design, with power contacts, for high continuous current, 1 changeover contact, input voltage 12 V DC
Coil side
Rated input voltage UN 12 V DC
Input voltage range 8.4 V DC ... 27 V DC
Typical input current at UN ...
|
|
Phoenix/Phoenix relay module DEK-REL- 24/1/SEN - 2964050
Relay module for sensors with solid state miniature relays, contacts (AgNi+Au): Small to medium loads, 1 normally open contact, input voltage 24V AC/DC, mountable on NS 35/7.5, module thickness 6.2 mm
advantage
Reduced costs due to the elimination of N-terminals
Most...
|
|
Phoenix/Phoenix Single relay with manually operated locking - REL-IR4/L-120AC/4X21 - 2903687
Plug-in industrial relay with power contacts, 4 PDTs, test keys, status LEDs, mechanical switch position display, coil voltage: 120 V AC
size
Width 21.2 mm
Height 27.5 mm
Depth 35.6 mm
Environmental conditions
Ambient temperature (operating) -40 °C ... 55 ...
|
|
Phoenix/Phoenix hybrid relay EMG 22-REL/KSR-G 24/TRN35 - 2952350
Relay module with miniature switching relay with integrated NPN transistor control, low control current, contact (AgNi): medium to large load, 1PDT, rated control voltage 24V DC
advantage
Low control current (module B), 0.5 mA depending on the model
Between the coil and the contacts ...
|
|
Relay module with manually operated locking - PLC-RPT- 24DC/21AU/MS - 2909672
PLC-INTERFACE, incl. PLC-BPT.../21 base terminal, plug-in connection, with manually operated plug-in miniature relay with multi-layer gold-plated contacts, 1 changeover contact, 24 V DC input voltage
size
Width 6.2 mm
Height 80 mm
Depth 94 m ...
|
|
Phoenix/Phoenix Single relay with manually operated locking - REL-MR- 12DC/21AU - 2961163
Plug-in miniature power relay with multi-layer gold-plated contacts, 1 PDT, input voltage 12 V DC
advantage
Secure isolation between coil and contact in accordance with DIN EN 50178
Depending on the model, the maximum degree of protection up to RT III (wash-resistant)
The maximum contact power is 6 A
Ruler...
|
|
Phoenix/Phoenix Single relay with manually operated locking - REL-MR - 24DC/21HC/MS - 2987888
Plug-in miniature relay with power contact, 1 PDT, test key, mechanical switch position display, status LED, freewheeling diode, polarity A1+, A2, input voltage 24 V DC
advantage
The strap can detect manual operation
Integrated status LEDs
Switching current up to 16 A
Mechanical ...
|
|
RIF-2-RSC-LV-120AC/2X21 - 2903322
Prefabricated relay modules with screw connections, including: relay bases, power contact relays, pluggable display/interference suppression modules, and brackets. Contact type: 2 changeover contacts. Input voltage: 120 V AC
The maximum power consumption under rated conditions is 1.56 W
Test voltage ...
|
|
Phoenix/Phoenix relay module PLC-RPT- 72UC/21/RW - 2900319
PLC-INTERFACE for rail applications, including base terminals, with plug-in connection and plug-in miniature power contact relays, range: 0.7 x UN to 1.25 x UN, temperature class TX: -40 °C to +70 °C, 1 PDT, input voltage 72 V DC
Rated ...
|
|
Phoenix/Phoenix Time Relays Timing Relays - TR-ES-OFF-CC-24/240-10H - 2907320
Phoenix/Phoenix Time Relays Timing relay - TR-ES-OFF-CC-24/240-10H - 2907320 timer relay with delay release and an adjustable time range (50 ms - 10 h), supply voltage 24-48VDC/24-240VAC, 1 PDT
size
Wide...
|
|
Phoenix/Phoenix relay module PLC-RSC-120UC/ 1/SEN - 2966249
The PLC-INTERFACE is suitable for input functions, including the PLC-BSC.../SEN base terminal with screw connection with plug-in miniature power contact relay for mounting on DIN rail NS 35/7.5, 1 NO contact, input voltage 120 V AC/110 DC
Rated ...
|
|
Relay module with manually operated locking - PLC-RPT- 24DC/21-21AU/MS - 2910524
PLC-INTERFACE, including relay base and pluggable multi-layer gold contact relay with manual operation, integrated status LEDs and freewheeling diode, Push-in connection, 2 changeover contacts, input voltage: 24 V DC
size
Width 14 mm
Height 80 mm
Depth 104 ...
|
|
Contact
working hours
