Introduction: Germany Woehner/Wiener SECUR®60Classic EasyLiner D0 disconnector fuse set (busbar installation), suitable for 3-wire busbar system, suitable for D01 and D02 fuses, E18 / 63 A / 3 poles, suitable for busbars 12, 15, 20, 25, 30 x 5, 10 and special-shaped busbars.
Product parameters
Rated current (IEC): 63 A
Rated voltage (IEC) AC: 400 V
Rated isolation voltage Ui AC: 500V
Rated impulse withstand voltage Uimp: 6 kV
Class of use AC (IEC 60947-3): AC-22B (400 V)
Conditional short-circuit current rating with fuse: 50 kA / 400 V
Working class with fuse measurement: gG
Power Output:
At 80% typical load, the power consumption reaches 4.5W.
(The power consumption at full load is 7 W.) ）
Fuse combination appliances in accordance with IEC 60947-3 are only allowed to operate above the rated operating voltage when used as a fuse-type isolator without breaking capacity, when used in excess of the rated insulation voltage and marked accordingly.
Degradation coefficient due to environmental influence:
35°C 1.0
45°C 0, 9
55°C 0.8
For fuses and positioning parts in accordance with DIN VDE 0636-3 IEC / HD 60269-3 / HD 60269-3
A D02 fuse with a silver-plated end cap is recommended
The separation function between the incoming and outgoing connections is determined according to the opening requirements of the product standard for the switching mechanism
Mechanical values
W x H x D: 27 x 200 x 80
Weight: 33 kg/100
Number of poles: 3 lines
Suitable busbars: 12, 15, 20, 25, 30 x 5, 10 and profiled busbars
Frontal protection rating: IP20
Connecting ends
1.5 - 16 mm² round stranded conductors and fine conductors without conductor sleeves
1.5 - 16 mm² fine conductor with conductor sleeve*
1.5 - 10 mm² fine conductors with boots
1.5 - 10 mm² round single strand conductor
* 16 mm² pressed using the crimping tool PZ 16, product type Weidmüller or
Use the pressure pliers Crimpfox 25R, model Phoenix Contact
Side mounting of the connecting conductor without side module (incl.) is 6 mm², and in the case of side module, the side mounting of the connecting conductor is up to (including) 10 mm²
Raw material properties
Housing: temperature resistance up to 130°C,
Flame retardant according to UL 94,
Creep resistant CTI 600
Halogen-free
Switch: temperature resistance up to 125°C,
Flame retardant according to UL 94,
Creep resistance CTI 600,
Halogen-free
This article introduces Woehner products, if you are interested in Woehner, please also contact our staff, we look forward to your call, hope our technology and service can bring you a better experience.
The company has been customer-centric, the concept of creating value for customers, winning the market with quality and service, and sincerely hopes to cooperate with all sectors of society to create success, create brilliance together, and work together to create a better tomorrow! In line with the concept of credibility and service-oriented, the company warmly welcomes new and old customers to inquire, visit and negotiate business!
|
More on that
|
Woehner 33603 NH Fuse Type Disconnector 630A
Introduction: Germany Woehner/Wiener QUADRON®60Classic NH fuse type disconnector, size 3, 630 A, busbar, upper/lower connection, screw M12, suitable for busbars 12, 20, 30 x 10 and special-shaped busbars.
...
|
|
Woehner/Wiener busbar mount fuse holder 33421 to connect top/bottom
Product Description: The 60mm busbar system technology is always modular, so it guarantees safety and flexibility, quick and easy installation, low maintenance costs and a durable solution. Around the world, more and more machinery manufacturing and equipment manufacturing enterprises trust and choose Winal ...
|
|
Woehner Motus® IO-Link Hybrid Motor Starter
Product Introduction: The MOTUS® Hybrid Motor Starter with IO-Link interface is a new product in the MOTUS® IO-Link family with networking functions that enables continuous communication between the control and device levels. The delivery of control instructions, the setting of control parameters, and the reading of equipment status can all be ...
|
|
Woehner 36152 Hybrid Switch 3-pole or 1-pole breaking
Introduction: Germany Woehner/Wiener hybrid switch, 3-pole or 1-pole disconnect with CrossLink®Technology technology, up to 25A continuous current with current monitor, using hybrid technology to achieve more than 30 million switching cycles.
...
|
|
Woehner 33600 NH Fuse Type Disconnector 250A
Description: Germany Woehner QUADRON®60Classic NH fuse type disconnector, size 1, 250 A, busbar, upper/lower connection, with CrossLink®Technology, for busbars 12, 15, 20, 25, 30 x 5, 10 and shaped busbars ...
|
|
Woehner 31935 D0 Fuse Header Busbar Type 27 MM
Introduction: Germany Woehner CUSTO®60Classic D0 fuse holder, busbar, 27mmE 18 / 63 A with touch protection for busbars 12, 15, 20, 25, 30 x 5, 10 and special-shaped busbars.
Products...
|
|
Woehner NH Fuse Disconnector 33801 Busbar Type
Introduction: Germany Woehner/Wiener NH fuse type disconnector, size 000, 125 A, busbar mounting, upper/lower connection. With CrossLink®Technology, the cover has a self-closing detection hole.
...
|
|
Woehner 31441 D FUSE HEADER BUSBAR, 42 MM
Introduction: Germany Woehner CUSTO®60Classic D fuse header, busbar, 42 mm locating bolt, E27/3 pole, suitable for busbars 12, 15, 20, 25, 30 x 5, 10 and special-shaped busbars.
Products...
|
|
Woehner 36200000A power supply
Product Introduction: The Woehner Power Supply 36200000A is directly mounted to the CrossBoard®, with an efficiency of 95%, an installation width of 45 mm, a self-protection function in case of a short circuit, a smart restart function, no pre-fuse required, an overvoltage capacity of up to 6 kV power supply 10 ...
|
|
Woehner Strip Fuse Disconnector 33285 Screw M8
Introduction: Germany Woehner/Wiener bar fuse type disconnector 160A, screw M8 / hook 70 mm², with electronic fuse monitor, suitable for busbars 12, 15, 20, 25, 30 x 5, 10 and special-shaped busbars.
...
|
|
Woehner 33079 NH Fuse Type Disconnector 160 A
Introduction: Germany Woehner/Wiener QUADRON®60Classic NH fuse type disconnector, size 00, 160 A, busbar mounting, upper/lower connection, screw M8 for 5-wire system, suitable for busbars 12, 15, 20, 25, 30 x 5, 10 and special-shaped busbars.
...
|
|
Wiener busbar system closure element 185mm - System power 250
Introduction: The great advantage of the Wiener bus system enclosed element 185mm-System power 250 Wiener bus system is that the components are attached to the bus, and the bus bar is connected without holes.
Features:
Safe and reliable: fully enclosed ...
|
|
Woehner CRITO CrossBoard Connection Module 50mm²
Description: Woehner/Wiener CRITO CrossBoard new 125 A connection module. The CrossBoard can be powered by connecting the module via CRITO. It is possible to connect and supply power to two CrossBoard base systems at the same time. The width of the CRITO connection module is 45 mm, ...
|
|
Woehner Switching Isolator with Fuse 33506 Tripole
Product Description: The 60mm busbar system technology is always modular, so it guarantees safety and flexibility, quick and easy installation, low maintenance costs and a durable solution. Around the world, more and more machinery manufacturing and equipment manufacturing enterprises trust and choose Winal ...
|
|
Woehner Power BROOME10® voltage 24 Vdc
Description: The Broome10® is Wienal's first 24 Vdc power supply for automation and control systems to be plugged directly into the CrossBoard® base system. The excellent conversion efficiency of this product is 95%, and the selection of high-quality components ensures that the product has low power loss, ...
|
|
Woehner Busbar Mounting Fuse Holder 33422 with Box Terminals
Product Description: The 60mm busbar system technology is always modular, so it guarantees safety and flexibility, quick and easy installation, low maintenance costs and a durable solution. Around the world, more and more machinery manufacturing and equipment manufacturing enterprises trust and choose Winal ...
|
|
Woehner 32590 Busbar Adapter for busbars 12 x 5, 10
Description: Germany Woehner EQUES 30Compact busbar adapter 32A, 1 adjustable support rail, 45 x 160, with conductor AWG 10 (6 mm²), for busbar 12 x 5, 10 snap-on mechanism for sliding on busbar, ultrasonic casting at the end of the conductor.
...
|
|
Woehner 33234 Strip Fuse Disconnector 160 A
Introduction: Germany Woehner/Wiener strip fuse type disconnector 160A, screw M8 / pressure plate 70 mm², size 00, suitable for busbars 12, 15, 20, 25, 30 x 5, 10 and special-shaped busbars.
Features:
...
|
|
Woehner 33602 NH Fuse Type Disconnector 400A
Description: Germany Woehner QUADRON®60Classic NH fuse type disconnector, size 2, 400 A, busbar, upper/lower connection, screw M10, for busbars 12, 20, 30 x 10 and special-shaped busbars.
...
|
|
Woehner 32628 bus adapter size 18x160x73mm
Introduction: Germany Woehner / Wiener EQUES®30Compact busbar adapter, 1 pole, 63 A. 1 fixed support rail for Schneider Electric iC60, iC65 and C60. For busbar 12 x 5
...
|
|
Contact
working hours
