Japan RIKA RKC resin pressure sensor CZ-200P
Main features
environmental protection
The push rod conduction method is adopted, and there is no polluting resin such as mercury.
High reliability and precision
The triple structure of the impulse section and the design of the impulse tube cover reduce heat from the outside or changes in the display during tightening. (Pressure tube cover is optional)
The combination of a built-in linearization display and an inverter enables high-precision pressure measurement with the highest accuracy of 0.5% FS. (Linearization correspondence optional)
A temperature sensor can be built-in
Built-in thermocouple temperature sensor type. Resin pressure and temperature can be measured with a single mounting port. (Thermocouple: K, J type class 2)
Compatible with high temperatures up to 550°C
Supron alloy diaphragm is available for a maximum service temperature of 550°C and corrosion resistance. It is possible to measure the pressure of functional resins such as polymeric resins.
*If the temperature sensor is a J-type thermocouple, it is 450°C.
Main specifications:
Pressure conversion mode: Strain gauge Wheatstone bridge
Range (Rated Pressure): Please refer to the Pressure Range Specification Table
Accuracy and line type: Within ±1% span (at 150°C for SUS630 diaphragm)
*±2% for types larger than 70MPa
*In the case of SPRON alloy film specifications
10, 20, 70MPa and the temperature above 480°C: 2.0% of the ± of the span
At 100MPa: 2.0% of ± span
100MPa and above 480°C: ± of span 4.0%
*Please contact our sales staff for HASTELLOY C alloy film specifications.
Hysteresis: within 0.5% of the ± of the span
* ±1% for 50 MPa or more, ±2% for 70 MPa or more, ±0.2% for 1 MPa
*In the case of SPRON alloy film specifications
70MPa or less: 1.0% of the ± of the span
10, 20, 70MPa and the temperature above 480°C: 2.0% of the ± of the span
At 100MPa: 2.0% of ± span
100MPa and above 480°C: ± of span 4.0%
*Please contact our sales staff for HASTELLOY C alloy film specifications.
Maximum film operating temperature: 400°C (550°C for SPRON film)
The maximum operating temperature of the pressure conversion bridge: 200°C
* If the surface temperature under the outer cylinder (nut side) reaches 180°C or more, the pressure measurement area is about 200°C. If the pressure measurement area exceeds 200°C, there is no guarantee that its performance will be maintained. It is recommended to use insulation materials to isolate the heat source, and the overall temperature should not exceed 180°C. When installing this sensor, different mounting directions (e.g. bevel, horizontal, etc.) may also improve the overheating condition of the sensor.
Allowable load pressure: 120% of span (500% for 1MPa, 1000% for 0.5MPa)
On-line coincidence rate % (1000% for 1MPa, 2000% for 0.5MPa)
Optional specifications
Temperature sensor type: Thermocouple K, J (non-grounded Class2)
Temperature measurement part: pressure measurement diaphragm surface measurement 2mm
Maximum operating temperature: 550°C (Type K thermocouple), 450°C (Type J thermocouple)
The company has been customer-centric, the concept of creating value for customers, winning the market with quality and service, and sincerely hopes to cooperate with all sectors of society to create success, create brilliance together, and work together to create a better tomorrow!
|
More on that
|
RKC thermostat RH100AD06-M*NN/Pt100, JPt100/rated 0.5A
Main features
Adjustable Control Responsiveness (POST Fine-Tuning Function)
The responsiveness of the PID control characteristics calculated by the automatic calculation (AT) can be easily adjusted through the POST fine-tuning function. And you can choose from 6 levels of POST fine-tuning function to choose the sound you need.
|
|
Japan Rika RKC CH series digital display controller Sampling cycle: 0.5 seconds
Main features
Adopt a large LED display
The large LED display can also be seen from a distance
Equipped with a self-tuning function of the judgment control state type
When the control state is judged to be disordered, the PID parameters are automatically adjusted
Loaded with auto-tuning function
...
|
|
Japan RIKA RKC SST series three-phase solid state relay
Product Introduction:
Japan Rika RKC SST series three-phase solid-state relay, screw-mounted type, equipped with a function to detect component faults.
1) Screw mounting type
2) Maximum load capacity: AC10A, AC20A, AC30A
3) Power supply voltage: AC...
|
|
Japan Rika RKC resin pressure digital display controller HA930 Sampling cycle: 0.025 seconds
Main features
It can be connected directly to a strain gauge resin pressure sensor
It can be directly connected and controlled with our pressure sensors.
High-speed sampling cycle of 0.025 seconds
The high-speed sampling cycle can be carried out in response to rapidly changing processes.
|
|
Japan RIKA RKC Thermostat SB1 A single-channel thermostat with built-in SSR
Product Introduction:
Japan RIKA RKC Thermostat SB1, a single-channel thermostat with built-in SSR, which can be directly connected to the load; The installation method supports pipe winding, pipe suspension, wall installation, and DIN track installation; Miniaturized size and built-in fuse. ...
|
|
Japan RIKA RKC GZ series (GZ400/GZ900) digital display controller
Main features
Ultra-high-speed sampling control of 10ms
With ultra-high-speed feedback control of 100 times per second, it is very effective in controlling high-speed changes in pressure, flow rate, pulse heat, etc., which are difficult to control until now.
It is equipped with a front exclusive communication interface
Whole...
|
|
Japan RIKA RKC communication converter COM-ME-1 Mass: about 150g
Introduction: Japan Rika RKC COM-ME-1 is a communication converter for our SRZ series, FZ series, and GZ series and Ethernet (MODBUS/TCP) connection.
peculiarity
This converter is used to connect our SRZ series, FZ series, and GZ series to ...
|
|
RKC Thermostat CD701FD03-MM*NN-5N Sampling cycle: 0.5 seconds
Main features
Equipped with a self-tuning function of the judgment control state type
When the control state is judged to be disordered, the PID parameters are automatically adjusted
Loaded with auto-tuning function
Can be installed in close proximity
It can be installed in close contact, using the control panel or operating ...
|
|
Japan physical and chemical RKC communication converter COM-ME-3 communication speed 38400 bps
Introduction: Japan RIKA RKC COM-ME-3 communication converter is a communication converter for our SRZ series, FZ series, and GZ series to connect with EtherCAT.
peculiarity
This converter is used to connect our SRZ series, FZ series, and GZ series to Ethernet ...
|
|
Japan RIKA RKC thermostat RH100 working voltage 220V
Product Details
Control Type: Temperature
Model: RH100
Opening size: 40.5*40.5
Mounting type: card type
Output signal: 4-20mA
Operating voltage: 220V
Dimensions: 48*48*100mm
...
|
|
Japan RIKA RKC USB communication converter COM-KG Weight 50g
Introduction: Japan RIKA RKC USB communication converter COM-KG is used to connect with RKC production controllers, RKC special communication of displays, or RS-485/422A serial communication and convert to USB connector and computer connection.
Features:
For USB and RKC dedicated communication, or USB ...
|
|
Japan RKC Physical and Chemical Resin Pressure Display Controller HA930 Weight 2kg
Product parameters
Brand: RKC/Physicochemical
Model: HA930
Type: Digital Display Controller
Mounting form: embedded
Cut-out size: 5mm
Operating voltage: 220V
Output signal: 100
Customization: No
...
|
|
Japan RIKA RKC PG500 resin pressure sensor Abundant input and output
Main features
Equipped with a large LED display
A large, high-brightness LED display is used to achieve visibility even from a distance
Abundant inputs and outputs
Equipped with digital input, analog output, alarm output, communication function, etc.
Product Introduction
...
|
|
Japan physical and chemical RKC temperature controller RD400DK01-MM3*NN5N/AN
Product Introduction
Digital Display Controllers (Temperature Controllers)
RD Series (RD100 / RD400 / RD500 / RD700 / RD900)
Measurement accuracy: ±0.2% of displayed value
Sampling cycle: 0.25 seconds
11-segment LCD display
Dedicated Loader...
|
|
Japan Rika RKC FB series (FB100 / FB400 / FB900) digital display controller
Main features
Rich combination of event outputs
A wide variety of event output combinations.
Joint operation through communication functions
Communication between controllers is achieved through the joint operation function.
・Automatic heating up with learning function ...
|
|
Japan RIKA RKC communication converter COM-ME series SRZ: host communication
Main features
COM-ME-1
Ethernet (MODBUS/TCP) communication converter
This converter is used to connect our SRZ series, FZ series, and GZ series to an Ethernet network (MODBUS/TCP).
This converter is used to transfer our SRZ ...
|
|
RKC communication converter COM-A RS-422A/RS-232C serial communication
Main features
RS-422A—RS-232C communication converter
Used for signal conversion of RS-422A (4-wire type) and RS-232C.
Connected to machines: Various controllers manufactured by our company
Main specifications:
Interface RS-232C / RS-422A
...
|
|
Japan RKC physical and chemical back pressure level gauge LE100 voltage 220v
Product parameters
Brand Name: RKC
Model: LE100/LE110
Measuring range: 800m
Resolution: 900*890
Supply voltage: 220V
Dimensions: 800*900(mm)
Explosion-proof grade: Class 1
Main features ...
|
|
Japan physical and chemical RKC surface temperature probe ST-23 with DP350/700
Product Gallery:
Features:
The RKC surface temperature probe ST-23 uses a maximum temperature of 300°C
Reaction time: 0.8 sec (metal surface) / 5.4 sec (絶縁物surface)
RKC Surface Temperature Probe ...
|
|
RKC thermostat RS100-MMN*NN communication mode: RS-485
Main features
Large, high-brightness LED display is adopted
A large, high-brightness LED display that can be seen clearly from a distance
Equipped with a data management tool that supports controllers · display settings, PROTEM2
A long-life type that can be used with peace of mind
Loading long ...
|
|
Contact
working hours
