Product Brief Introduction of VFD750V43C-2:Output frequency 0.1-600Hz Robust PDFF control with servo Set PI gain and bandwidth at 0 speed, high and low speed With the speed closed-loop control mode, the torque can be maintained at zero speed up to 150% Overload: 150% up to one minute, 200% up to two seconds
Delta inverter:
DELTA Inverter VFD-VE High Performance Magnetic Beam Vector Control Type:
▲ Output frequency: 0.1-600Hz
▲ Robust PDFF control with servo
▲ Set PI gain and bandwidth at 0 speed, high and low speed
▲ With the speed closed-loop control mode, the torque can reach 150% at zero speed
▲ Overload: 150% up to one minute, 200% up to two seconds
▲ Origin reset, pulse following, point-to-point position control at 16 points
▲ Position/speed/torque control mode
▲ Super tension control, rewinding and unwinding function
▲ 32-bit CPU, the high-speed version can output up to 3333.4Hz
▲ Support dual RS-485, fieldbus and monitoring software
▲ Built-in spindle positioning tool change
▲ It can drive high-speed electric spindle
▲ Spindle positioning, rigid tapping ability, etc
Features:
●V/F, FOC+PG, TORQUE+PG, position control
●DOC+PG closed-circuit loop control, speed control up to 1:1000
● Built-in PID control
●It can be used to estimate motor parameters and load inertia
● 4 sets of independent S-curves and acceleration/deceleration times
●Mechanical brake control function
●Deceleration function in case of instantaneous power failure
●Motor Y-switch function
● 10 groups of convenient communication blocks
●I/O serial positioning control
●Monitoring card and monitoring application software
●It has the function of automatic energy saving under light load
●Motor temperature feedback protection function
●0 speed, high and low speed PI gain and bandwidth setting
●Origin reset, pulse following, point-to-point position control at 16 points
Model range:
Three-phase 230 V series: 0.75 - 37 kW (1 - 50 hp)
Three-phase 460 V series: 0.75 - 75 kW (1 - 100 hp)
The above is the product introduction of Delta/Delta Inverter VFD-VE Magnetic Beam Vector Control VFD750V43C-2, this product introduction is: output frequency 0.1-600Hz Robust PDFF control with servo PI gain and bandwidth setting at 0 speed, high and low speed With the speed closed-loop control mode, the holding torque can reach 150% at zero speed Overload: 150% up to 1 minute, 200% up to 2 seconds.
If you still have questions, you can communicate with customer service at any time, 76 Technology guarantees that all finished products are genuine and honest transactions. You choose 76 Technology, 76 Technology reports on the purchase experience with high quality, excellent service and strict control.
| 
Contact
working hours
